GB/T 2952.1-2008Protective coverings for electric cables - Part 1: General (English PDF)

1 Scope

This part of GB/T 2952 specifies the type, model designation, structure, dimension, technical requirements and test method of the protective coverings for electric cables (hereinafter referred to as "protective coverings").

This part is applicable to fixed formation power cables (including oil-filled cables), and communication, signal, control cables, etc. as well as optical cables.

The protective coverings which are not specified in this part and have other special requirement shall be specified separately in the corresponding product standards.

2 Normative references

The following documents contain provisions which, through reference in this part of GB/T 2952, constitute provisions of this part. For dated references, subsequent amendments (excluding corrections), or revisions, of any of these publications do not apply to this part. However, parties to agreements based on this part are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies.

GB/T 2059-2000 Strips of copper and copper alloys

GB/T 2696-1987 Skeined colour jute threads — Technical requirements and grading stipulation

GB/T 2900.10 Electrotechnical vocabulary — Electric cables (GB/T 2900.10-2001, idt IEC 60050(461):1984)

GB/T 2951.11-2008 Common test methods for insulating and sheathing materials of electric and optical cables — Part 11: Methods for general application — Measurement of thickness and overall dimensions — Tests for determining the mechanical properties (IEC 60811-1-1:2001, IDT)

GB/T 3048.10-2007 Test methods for electrical properties of electric cables and wires — Part 10: Spark test of extruded protective sheaths

GB/T 3082-1984 Galvanized low carbon steel wire for armouring cables;

GB/T 12706.1-2008 Power cables with extruded insulation and their accessories for rated voltages from 1kV (Um=1.2kV) up to 35kV (Um=40.5kV) — Part 1: Cables for rated voltage of 1kV (Um=1.2kV) and 3kV (Um=3.6kV) (IEC 60502-1:2004, Power cables with extruded insulation and their accessories for rated voltages from 1kV(Um=1.2kV) up to 30kV(Um=36kV) — Part 1: Cables for rated voltage of 1kV(Um=1.2kV) and 3kV(Um=3.6kV), MOD)

JB/T 10696.3-2007 Test methods for determining mechanical physical and chemical properties of electric cables and wires — Part 3: Bending test

JB/T 10696.4-2007 Test methods for determining mechanical physical and chemical properties of electric cables and wires — Part 4: Test for copper naphthenate content of protective coverings

JB/T 10696.5-2007 Test methods for determining mechanical physical and chemical properties of electric cables and wires — Part 5: Corrosion spread test

JB/T 10696.6-2007 Test methods for determining mechanical physical and chemical properties of electric cables and wires — Part 6: Test for abrasion of oversheaths

SH/T 0001-1990 Cable asphalt

YB/T 024-2008 Steel strips for cable armouring

3 Terms and definitions

For the purposes of this part, the terms and definitions given in GB/T 2900.10 and the following apply.

4 Type and model designation