GB/T 22358-2008Earth-moving machinery -- Preservation and storage (English PDF)

3.1 General requirements

3.1.1 protective treatment including dismantling, marking, protective preparation, job protection and final packaging.

3.1.2 Unless otherwise specified in the purchase order or sales contract, the manufacturer shall manufactured machine parts and protective treatment.

3.1.3 All materials and machine parts used for protection, regulation should be consistent with this standard contract or sales agreement and the corresponding technical documents Set, and during the period of protection provided, shall ensure the safe custody of the machine.

3.1.4 before the protective treatment, the metal surface of the machine should be no rust, paint layer, a metal plating or other coatings can not be damaged. Of used After the machine should be required to repair, and then protective treatment.

3.1.5 protective treatment should be under appropriate conditions (ambient temperature and humidity) carried out to ensure the protection of the quality of materials should be used, and should pay attention Safety and environmental protection.

3.1.6 protective treatment has been carried out for each machine, should provide clear procedures shield. This procedure can be used as a separate section attached Division Machine use and maintenance manual.

3.1.7 protection procedures and remove the shield should be installed in the same procedure within a waterproof marker, obviously on the machine parts.

3.1.8 Clear shield procedures should provide for storage and transportation category, date protection and protective expiration date. Regulations should also be regulated the method of re-assembled set clear shield method and detached parts, and the provisions of these tools and equipment required for the operation of list.

3.1.9 for protection job and clear the shield operation, should pay attention to prevention of accidents in general. Where necessary, this bill by the GB/T 22358-2008/ISO 6749. 1984