GB/T 15499-1995The lost workdays standard for injury accidents (English PDF)

3 Terms

4 Injuries to the limbs

5 Injuries to the eye

6 Injuries to the nose

7 Injuries to the ear

8 Injuries to the oral and maxillofacial region

9 Injuries to the scalp, skull and brain

10 Injuries to the neck

11 Injuries to the chest

12 Injuries to the abdomen

13 Injuries to the pelvis

14 Injuries to the spine

15 Other injuries

Foreword

This document was issued on 10 March 1995 by the State Administration for Market Regulation and the Standardization Administration of the People's Republic of China, and has been in force since 1 October 1995.

It is the first edition of this standard.

Classification: ICS 13.100, CCS C75.

About this edition

GB/T 15499-1995 is the first edition of this standard. It was issued on 10 March 1995 and has been in force since 1 October 1995.

There is no earlier edition to compare it with, so a specification that has to refer to this subject can only cite GB/T 15499-1995 itself.

The interval between issue and effect is the transition period. It exists so that producers, laboratories and buyers can requalify products, revise procedures and use up documentation before the new text becomes the one that applies. The date on this page is the official one from the record of the Standardization Administration.

Classification and status

GB/T 15499-1995 is classified under ICS 13.100, in the field of environment and health protection, safety. ICS is the International Classification for Standards, the same scheme used by ISO and by the national bodies of most countries, which is what allows a Chinese standard to be placed beside its foreign counterparts on subject rather than on number.

Its Chinese Standard Classification code is CCS C75. CCS is the domestic scheme, a letter for the sector and two digits for the subject within it, and it is the code by which the standard is filed and searched in China.

The GB/T prefix marks a recommended national standard. It is not, in itself, law: it becomes binding when a contract names it, when a regulation or a mandatory standard refers to it, or when a producer declares conformity with it. In practice that covers most of the cases in which it will be read — a purchase specification, an inspection agreement or a certification scheme.