GB/T 25969-2010Specification of material selecting for main parts of domestic solar water heating system (English PDF)

Foreword

This standard is GB/T 19141-2003 "domestic solar water heating systems" supporting standards.

1 Scope

This standard specifies the selection principles of domestic solar water heating systems main components, technical requirements, test methods, inspection rules.

This standard applies to hot water storage tank capacity not greater than the main components of 0.6m3 domestic solar water heating systems.

2 Normative references

The following documents contain provisions which, through reference in this standard and become the standard terms. For dated references, subsequent Amendments (not including errata content) or revisions do not apply to this standard, however, encourage the parties to the agreement are based on research Whether the latest versions of these documents. For undated reference documents, the latest versions apply to this standard.

GB/T 706 hot-rolled steel

GB/T 1043.1 Plastics - Determination of Charpy impact properties - Part 1: Non-instrumented impact test

GB/T 1527 copper and copper alloy tube drawing

GB/T 1634.2 Determination of plastic deflection temperature under load - Part 2: Plastics, ebonite and long-fiber-reinforced composite materials

GB/T 1732 Determination of impact resistance of film

GB/T 1740 Determination of resistance to wet heat

GB/T 1766 Paints and varnish coating aging rating method

GB/T 1771 Determination of Paints and varnishes resistance to neutral salt spray

GB/T 1865 Paints and varnishes - Artificial weathering and exposure to artificial radiation filtered xenon arc radiation

GB/T 2059 copper and copper alloy strip

GB/T 2406.2 Determination of burning behavior of plastics - Part 2 oxygen index. room temperature test

GB/T 2518 continuous hot-dip galvanized steel sheet and strip

GB/T 2828.1 Sampling procedures for inspection - Part 1. by acceptance quality limit (AQL) retrieval batch inspection sampling plan

GB/T 2829 periodic inspection Sampling procedures and tables (suitable for process stability test)

GB/T 3280 stainless steel cold-rolled steel sheet and strip

GB/T 3880.1 General industrial aluminum and aluminum alloy sheet, strip - Part 1: General requirements

GB/T 3880.2 General industrial aluminum and aluminum alloy sheet, strip Part 2: Mechanical Properties

GB 4706.12 Household and similar electrical appliances - Safety storage water heater Particular requirements

GB 5237.2 Aluminum Profiles - Part 2. anodized profiles

GB 5237.3 Aluminum Profiles - Part 3: Electrophoretic coating profiles

GB 5237.4 Aluminum Profiles - Part 4: Powder coating profiles

GB/T 6343 and foam rubber Determination of apparent density

GB/T 6424 flat plate solar collectors

GB/T 6461 on the metal base metals and other inorganic coatings by etching after the test specimens and ratings

GB/T 8811 rigid foam dimensional stability test methods

GB/T 8813 rigid foam compression Measuring performance

GB/T 9286 Paints and varnishes Cut test

GB/T 9341 Determination of plastic bending performance […]