GB/T 12497-2006Three-phase induction motor's economic operation (English PDF)

3 Terms and definitions

4 Principles and technical conditions for the economical operation of the electric motors

5 Weighted average overall efficiency and overall economic load factor of the motor operation

6 Replacement or modification of the motors

7 Testing of the operating state of the motor

8 Plan for the key motors

Foreword

This document was issued on 18 July 2006 by the General Administration of Quality Supervision, Inspection and Quarantine of the People's Republic of China and the Standardization Administration of China, and has been in force since 1 December 2006.

It replaces GB 12497-1995.

Classification: ICS 29.160.20, CCS A01.

About this edition

GB/T 12497-2006 is the current edition. It was issued on 18 July 2006 and has been in force since 1 December 2006, replacing GB 12497-1995.

GB 12497-1995 has been superseded: a specification that still cites it is citing a withdrawn edition.

The interval between issue and effect is the transition period. It exists so that producers, laboratories and buyers can requalify products, revise procedures and use up documentation before the new text becomes the one that applies. The date on this page is the official one from the record of the Standardization Administration.

Classification and status

GB/T 12497-2006 is classified under ICS 29.160.20, in the field of electrical engineering. ICS is the International Classification for Standards, the same scheme used by ISO and by the national bodies of most countries, which is what allows a Chinese standard to be placed beside its foreign counterparts on subject rather than on number.

Its Chinese Standard Classification code is CCS A01. CCS is the domestic scheme, a letter for the sector and two digits for the subject within it, and it is the code by which the standard is filed and searched in China.

The GB/T prefix marks a recommended national standard. It is not, in itself, law: it becomes binding when a contract names it, when a regulation or a mandatory standard refers to it, or when a producer declares conformity with it. In practice that covers most of the cases in which it will be read — a purchase specification, an inspection agreement or a certification scheme.