GB/T 37089-2018Reciprocating internal combustion engine driven alternating current generating sets—Controller (English PDF)

Foreword

This standard was drafted in accordance with the rules given in GB/T 1.1-2009.

1 Scope

This standard specifies the terminology and definition of the controller for the marine and marine alternator (hereinafter referred to as the unit) driven by the reciprocating internal combustion engine. Requirements for classification, classification, technical requirements, inspection rules, test methods, marking, labeling, packaging, storage and transportation, and manufacturing facilities.

This standard is applicable to controllers for units with rated voltage not higher than 500V and rated frequency 50Hz.

60Hz AC generator set, DC generator set, intermediate frequency generator set, dual frequency generator set and high voltage generator set controller Refer to use.

2 Normative references

The following documents are indispensable for the application of this document. For dated references, only dated versions apply to this document. For undated references, the latest edition (including all amendments) applies to this document.

GB/T 1690-2010 Vulcanized rubber or thermoplastic rubber liquid test method

GB/T 2423.1 Environmental testing of electrical and electronic products - Part 2: Test methods Test A. Low temperature

GB/T 2423.2 Environmental testing of electrical and electronic products - Part 2: Test methods Test B. High temperature

GB/T 2423.3 Environmental testing of electric and electronic products - Part 2: Test method test Cab. constant damp heat test

GB/T 2423.4 Environmental testing of electric and electronic products - Part 2: Test methods Test Db. alternating heat and damp (12h 12h ring)

GB/T 2423.5 Environmental testing of electric and electronic products - Part 2: Test methods Test Ea and guide. Impact

GB/T 2423.6 Environmental testing for electric and electronic products - Part 2: Test methods Test Eb and guide. Collision

GB/T 2423.10 Environmental testing of electric and electronic products - Part 2: Test method test Fc. Vibration (sinusoidal)

GB/T 2423.18 Environmental test - Part 2: Test method Test Kb. salt spray, alternating (sodium chloride solution)

GB/T 2423.22 Environmental testing - Part 2: Test methods Test N. Temperature change

GB/T 2423.24 Environmental testing - Part 2: Test methods test Sa. Simulating solar radiation on the ground and its test guidelines

GB/T 2820.4-2009 Reciprocating internal combustion engine driven alternators - Part 4: Controls and switchgear

GB/T 2820.6-2009 Reciprocating internal combustion engine driven alternators - Part 6: Test methods

GB/T 4208-2017 enclosure protection grade (IP code)

GB 4793.1-2007 Safety requirements for electrical equipment for measurement, control and laboratory - Part 1: General requirements

GB/T 5169.16 Fire hazard testing for electric and electronic products - Part 16: Test flame 50W Horizontal and vertical flame test method

GB/T 6113.102 Radio disturbance and immunity measurement equipment and test methods - Part 1-2. Radio disturbance and immunity Degree measurement equipment auxiliary equipment conduction disturbance

GB/T 6113.201 Radio disturbance and immunity measuring equipment and measuring methods - Part 2-1. Radio disturbance and immunity Degree measurement method

GB/T 6113.203 Radio disturbance and immunity measuring equipment and measuring methods - Part 2-3. Radio disturbance and immunity Degree measurement method radiation disturbance measurement

General technical conditions for GB/T 13384 mechanical and electrical product packaging