GB/T 32045-2015Guidance on implementation of measurement and verification of energy savings (English PDF)

1 Scope

This standard specifies the energy-saving technological transformation projects (hereinafter. Project) savings measurement and verification of implementation procedures, techniques and reporting prepared by.

This standard applies to project energy savings measurement and verification of implementation.

2 Normative references

The following documents for the application of this document is essential. For dated references, only the dated version suitable for use herein

Member. For undated references, the latest edition (including any amendments) applies to this document.

GB/T 2587 General equilibrium energy using equipment

GB/T 6422 energy-using equipment to test guidelines

GB/T 8222 General electrical equipment, energy balance

GB/T 13234 method of calculating energy companies

GB/T Section 28750 of energy measurement and verification techniques General

GB/T 31349-2014 energy measurement and verification section technical requirements for central air conditioning system

3 Terms and Definitions

GB/T 13234, the terms and definitions GB/T 28750 apply to this document defined.

4 implementation steps

Measurement and verification of energy savings includes the following implementation steps.

a) Prepare measurement and verification program. Measurement and verification program preparation, including division of the project boundary, determine the statistical base period and the reporting period, the election

Take methodology, the data collection program and results accuracy requirements and other four job content. This work is a four cycle

Reciprocating dynamic process, the need to constantly revise and improve relevant content until a technically feasible and economically reasonable measurement and verification

Program.

b) identify and record the measurement and verification program. Before the start of the project construction and implementation, should step a) the content of the work of a written text

Member. Content measurement and verification programs should be consistent with GB/T 28750 requirements. Measurement and verification program example in Appendix A. in

For implementation of the project on the measurement and verification program changes should be recorded in writing to change the situation.

c) to determine the energy consumption data and factors influencing the base period.

d) the design, installation and commissioning of test equipment. According to the requirements of measurement and verification programs in project design and construction process should be synchronized set

Design, installation and commissioning for the measurement and verification of test equipment.

e) determining the statistical reporting of energy consumption data and factors.

f) to determine the energy savings. If necessary, it is reasonable to set the calibration value to adjust the energy consumption and energy consumption should be a written record set calibration adjustment value

Setting process and results.

g) the audit report or savings have been identified.