GB/T 31518.1-2015Direct-drive permanent magnet type wind turbine generator system—Part 1: Technical condition (English PDF)

Foreword

GB/T 31518 "direct drive permanent magnet wind turbine" is divided into two parts.

--- Part 1. Technical conditions;

--- Part 2. Test methods.

This section GB/T Part of 131,518.

This section drafted in accordance with GB/T 1.1-2009 given rules.

1 Scope

GB/T 31518 provisions of this part of the direct-drive permanent magnet wind turbine environmental conditions, technical requirements, test methods, inspection rules As well as storage, delivery and other requirements.

This section applies to rotor swept area greater than 200m2 of horizontal axis wind turbine permanent magnet direct-drive (hereinafter referred to as "units") Products Design, manufacturing, packaging, transportation and inspection.

2 Normative references

The following documents for the application of this document is essential. For dated references, only the dated version suitable for use herein Member. For undated references, the latest edition (including any revisions) applicable to this document.

GB/T 191 Packaging - Pictorial signs

GB/T 2900.18 Electrotechnical term low-voltage electrical

GB/T 2900.53 Electrotechnical terminology Wind Turbine

GB/T 6388 transport package shipping mark

GB/T 12325-2008 power quality supply voltage deviation

GB/T 12326-2008 power quality voltage fluctuation and flicker

GB 12668.3 speed electric drive systems - Part 3. EMC requirements and specific test methods

GB/T 14549-1993 power quality utility grid harmonic

GB/T 15543-2008 power quality three-phase voltage unbalance

GB/T 15945-2008 power quality power system frequency deviation Part 5-54 GB 16895.3-2004 Electrical installations of buildings. Selection and erection of electrical equipment grounding configuration protection guide Body and protective bonding conductors

GB 18451.1 wind turbine design requirements

GB/T 19069 wind turbine controller Technical conditions

GB/T 19072-2010 wind turbine tower Corrosivity of atmospheres - Classification GB/T 19292.1-2003 metals and alloys

GB/T 19568-2004 wind turbine assembly and installation specifications

GB/T 19960.1-2005 wind turbines - Part 1. General requirements

GB/T 19963-2011 wind farm power system technical requirements

GB/T 25383-2010 wind turbine rotor blades

GB/T 25387.1 wind turbine full power converters - Part 1. Technical conditions

GB/T 25389.1 low-speed permanent magnet synchronous wind turbine generators - Part 1. Technical conditions GB /Part 2 T 25389.2 low-speed permanent magnet synchronous wind turbine generators. Test methods GB /Z25427 wind turbine lightning protection GB /Z25458 wind turbine qualified certification rules and procedures Test Method. GB/T 31518.2 wind turbine permanent magnet direct-drive Part 2