GB/T 25362-2010Electromechanical solenoid fuel injector assemblies of gasoline engines - Technical requirements (English PDF)

1 Scope

This standard specifies the gasoline injector solenoid valve (hereinafter referred to as injector) terms and definitions, technical requirements, inspection rules, marking,

Packaging, transport and storage.

This standard applies to the fuel injection pressure in the range of 150kPa ~ 450kPa injector.

2 Normative references

The following documents contain provisions which, through reference in this standard and become the standard terms. For dated references, subsequent

Amendments (not including errata content) or revisions do not apply to this standard, however, encourage the parties to the agreement are based on research

Whether the latest versions of these documents. For undated reference documents, the latest versions apply to this standard.

GB/T 2828.1 Sampling procedures for inspection - Part 1. by acceptance quality limit (AQL) retrieval batch inspection sampling plan (GB/T 2828.1-2003, ISO 2859-1.1999, IDT)

GB/T 2829 periodic inspection Sampling procedures and tables (suitable for process stability test)

GB/T 10125 artificial atmosphere corrosion test salt spray test (GB/T 10125-1997, eqv ISO 9227.1990)

GB/T 13384 mechanical and electrical products packaging General technical conditions

GB/T 14986 high saturation magnetic compensation temperature, corrosion, almandine, constant magnetic permeability soft magnetic alloy

Motor gasoline GB 17930

GB 18351 vehicle ethanol gasoline

GB 18655-2002 Limits and methods of measurement used (idt IEC /CISPR25 protection onboard receiver of radio disturbance characteristics.

1995)

QC/T 413-2002 automotive electrical equipment basic technical conditions

QC/T 417.1 ~ 417.5 car harness connector

3 Terms and Definitions

The following terms and definitions apply to this standard.