GB/T 24645-2009slush seal performance of tractors - Test procedures (English PDF)
拖拉机防泥水密封性 试验方法
This is a limited preview
Buy now to download the full PDF (15 pages)
Need quotation for your management?
Get a formal quotation for GB/T 24645-2009 in 30 minutes.
Issued by
SAMR; SAC
Level / Type
National · Recommended
Issue date
November 15, 2009
Implementation date
May 1, 2010
Scope
GB/T 24645-2009 is the English-translated version of 拖拉机防泥水密封性 试验方法.
GB/T 24645-2009 is the Chinese standard "slush seal performance of tractors - Test procedures". Its scope clause reads: This standard specifies the tractor anti-water tightness test methods.
This standard applies to floods, droughts and dual-use guide wheel radius or minimum static ground clearance <=500mm wheeled tractors and tractor Crawler Tractors anti-water tightness test, Ship tractors and paddy field operations can be implemented by reference.
Its clauses include test equipment; test method; determine the test results; test report.
Found what you need?
Document preview — GB/T 24645-2009
National Standard of the People's Republic of China
- ICS
- 65.060.10
- Classification
- T 61
Issued by: State Administration for Market Regulation; Standardization Administration of the PRC
Contents
- 1 Scope
- 2 Test Equipment
- 3 Test Method
- 4 determine the test results
- 5 Test Report
1 Scope
This standard specifies the tractor anti-water tightness test methods.
This standard applies to floods, droughts and dual-use guide wheel radius or minimum static ground clearance <=500mm wheeled tractors and tractor
Crawler Tractors anti-water tightness test, Ship tractors and paddy field operations can be implemented by reference.
2 Test Equipment
In the facility can choose one of the following.
a) an annular mud sink width should meet the operational requirements of 3.3 tests, mud tank depth adjustable. Mud clay content of about 25% (Mass percentage);
Length and width b) mud pool can accommodate the entire tractor, mud pool depth adjustable. About 25% of clay mud content (percent by mass
Division ratio). Stir in the mud pool mud mixing and loading of the tractor should have the means.
3 Test Method
3.1
The test shall be the date of shipment from the tractor does not exceed six months, and the working time is not more than 150h (including running, test time) love
Carried out under conditions.
3.2
Tractor test in the mud duration of 2h.
3.3
When the annular slurry tank tested by the tractor driver's steering or traction device traction. To impose its rated towing tractor
30% of the power load, wheeled tractor close to 6km/h speed driving cycle; tractor close to 4km/h speed loop
Driving. When wheeled tractor test, the water in line with the guide wheel center line, but when the guide wheel static radius greater than 400mm, adjust the water,
So that each of the wheels with a draft of 400mm; when the tractor test, the water is consistent with the drive wheel axis.
3.4
when tested in the mud pool, the tractor should work at the state level, to impose its calibration tractor traction load of 30%
The line speed for the Netherlands, each wheel tractor shall comply with the provisions of 3.3. When wheeled tractor test, the water in line with the guide wheel center line, but
When static wheel radius greater than 400mm guide, adjust the water so that all the wheels with a draft of 400mm; when the tractor test, the water and flooding
Fixed axle center line of the same.
After 3.5 prototype test at dry place to stand more than 12h, allowed to percolate until external no residual traces of water, oil spills inspection and dismantling rounds
Axis, carried into the mud examination steering oil seal section.
3.6
pairs of lubricating oil, grease and electric iron by visual exploration methods water testing. When the probe electric iron, electric iron should be fully preheated, to be
After the first electric iron oiled surface fumes before use.
4 determine the test results
4.1
parts of a test by test seepage, leakage is determined that the oil spill.
4.2
Seal the inside edge and lubricants, grease seal cavity oil, tallow visible water droplets or electric iron exploration has crackle judged to feed
Muddy water.
5 Test Report
Tractors anti-water tightness test should complete test report, test report format in Appendix A.
GB/T 15370.3-2025 | GB/T 15370.2-2009 | GB/T 3871.6-2006 | GB/T 24642-2009 | GB/T 24641-2009 | GB/T 24640-2009 | […]
......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 15 pages — is available in the English PDF.
Referenced standards
Cited by
- GB/T 15370.7-2017Agricultural tractors—General requirement—Part 7: Three-wheel boat tractors
- GB/T 15370.6-2016Agricultural tractors - General requirements - Part 6: Four-wheel boat tractors
- GB/T 13875-2015Walking tractors - General requirement
- GB/T 15370.1-2012General requirement of agricultural tractors - Part 1: Under 50 kW wheeled tractors
- GB/T 15370.4-2012General requirement of agricultural tractors - Part 4: Crawler tractors
- GB/T 15370.5-2012General requirement of agricultural tractors - Part 5: Belt-drive wheeled tractors
Similar standards
How to Download GB/T 24645-2009
- 1
Add to cart
Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.
- 2
Checkout
Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).
- 3
Instant delivery (0–9 sec)
Delivery is automatic: within seconds of payment you'll receive an email with a secure download link. The link stays valid for 72 hours.
- 4
Invoice included
A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.
Related Standards
GB/T 10003-2026 — Biaxially oriented polypropylene (BOPP) film
GB/T 10004-2026 — Plastic/Plastic laminated films and pouches for packaging
GB/T 10007-2026 — Rigid cellular plastics - Determination of shear properties
Secure payment via Stripe
Payments accepted
GB/T 24645-2009
$85.00