GB/T 15447-2008Conversion method of absorbed doses in different materials irradiated by X, gamma rays and election beams (English PDF)

3 Terms and definitions

4 Significance and use

5 Algorithm for the absorbed dose

6 Calculation of the absorbed dose in material B from the absorbed dose measured in material A

7 Method of the ratio of the mass energy absorption coefficients

8 Conversion of the absorbed dose between materials under electron beam irradiation

9 Accuracy

Foreword

This document was issued on 19 September 2008 by the State Administration for Market Regulation and the Standardization Administration of the People's Republic of China, and has been in force since 1 August 2009.

It replaces GB/T 15447-1995.

Classification: ICS 17.240, CCS A58.

About this edition

GB/T 15447-2008 is the current edition. It was issued on 19 September 2008 and has been in force since 1 August 2009, replacing GB/T 15447-1995.

GB/T 15447-1995 has been superseded: a specification that still cites it is citing a withdrawn edition.

The interval between issue and effect is the transition period. It exists so that producers, laboratories and buyers can requalify products, revise procedures and use up documentation before the new text becomes the one that applies. The date on this page is the official one from the record of the Standardization Administration.

Classification and status

GB/T 15447-2008 is classified under ICS 17.240, in the field of metrology and measurement. ICS is the International Classification for Standards, the same scheme used by ISO and by the national bodies of most countries, which is what allows a Chinese standard to be placed beside its foreign counterparts on subject rather than on number.

Its Chinese Standard Classification code is CCS A58. CCS is the domestic scheme, a letter for the sector and two digits for the subject within it, and it is the code by which the standard is filed and searched in China.

The GB/T prefix marks a recommended national standard. It is not, in itself, law: it becomes binding when a contract names it, when a regulation or a mandatory standard refers to it, or when a producer declares conformity with it. In practice that covers most of the cases in which it will be read — a purchase specification, an inspection agreement or a certification scheme.