YY/T 0608-2013General specifications for X-ray image intensifier TV system for medical diagnosis (English PDF)
医用X射线影像增强器电视系统通用技术条件
This is a limited preview
Buy now to download the full PDF (18 pages)
Need quotation for your management?
Get a formal quotation for YY/T 0608-2013 in 30 minutes.
Issued by
NMPA
Level / Type
Industry · Recommended
Issue date
October 21, 2013
Implementation date
October 1, 2014
Scope
YY/T 0608-2013 is the English-translated version of 医用X射线影像增强器电视系统通用技术条件.
YY/T 0608-2013 is the Chinese pharmaceutical industry standard that gives the general specifications for the X-ray image intensifier television system used in medical diagnosis.
It specifies the terms and definitions, the requirements and the test methods for a system built around a medical X-ray image intensifier and used for fluoroscopy, covering the resolution and the contrast of the displayed image, the signal to noise ratio, the distortion and the uniformity, the automatic brightness control and the safety of the equipment. Issued on 21 October 2013, it has applied since 1 October 2014.
Found what you need?
Document preview — YY/T 0608-2013
National Standard of the People's Republic of China
- ICS
- 11.040.50
- Classification
- C 43
- Replacing
- YY/T 0608-2007
Issued by: National Medical Products Administration of the People's Republic of China
Contents
- Introduction
- 1 Scope
- 2 Normative references
- 3 Terms and definitions
- 4 requires
- 4.1 effective incident field size
- 4.23 image distortion
- 4.3 contrast range
- 4.4 Identification of image gray level
- 4.5 line pair resolution
- 4.6 Low contrast resolution
- 4.7 image brightness stabilization signal
- 4.8 Video Output Voltage
- 4.9 Environmental Test
- 5.1 effective incident field size
- 5.25 image distortion Contrast range 5.3
- 5.4 Identification of the gray level image
- 5.5 line pair resolution
- 5.6 Low contrast resolution
- 5.7 stable image brightness signal
- 5.8 video output voltage
- 8
- 5.9 Environmental Testing
- Appendix A (normative) video output voltage measurement layout
- Appendix B (normative) vision and image distortion measurement layout
- Annex C (normative) Identification of the gray level image layout measuring
- Annex D (informative) image gray level test identification card
- Annex E (informative) low-contrast resolution test card
- Annex F (informative) line pair resolution test card
- Annex G (informative) vision and image distortion test card
- Appendix H (informative) test parameters, symbols and units
- 1 video output voltage Figure
Foreword
This standard was drafted in accordance with GB/T 1.1-2009 given rules.
With the increasingly widespread use of digital technology, medical X-ray imaging has been varying degrees of integration of digital technology. For Medical
Terms of use X-ray image intensifier television system, with the gradual deepening of digital technology, the original evaluation of medical X-ray image intensifiers
The TV system approach has changed. To make these new methods of standardization in the 2007 version of the standard was revised.
Instead of the standard YY/T 0608-2007 "medical X-ray image intensifier television system General technical conditions";
Compared with YY/T 0608-2007 The main technical differences are as follows.
--- Modify the description of the scope of the standard, to avoid the installation of medical X-ray image intensifier television system of medical X-ray machine Unable to cite this standard problem;
--- Remove the "incident air kerma rate" requirements and test methods;
--- Low contrast resolution requirements from 2% to 4.4%;
--- 5.4,5.5,5.6 original terms of reference GB 19042.1-2003 changed directly describe;
--- Added Appendix H test parameters, symbols and units;
--- Removed YY/T 0457.4-2003 of reference. Terms of reference defined directly.
1 Scope
This standard specifies the terms and definitions, requirements and test methods related to medical X-ray image intensifier television system.
This standard applies to the use of medical X-ray image intensifiers for medical X-ray image intensifier television system for X-ray fluoroscopy (Hereinafter referred to as television system, except in Chapter 3).
2 Normative references
The following documents for the application of this document is essential. For dated references, only the dated version suitable for use herein Member. For undated references, the latest edition (including any amendments) applies to this document.
GB 9706.1-2007 Medical electrical equipment - Part 1. General requirements for safety
GB/T 10149-1988 X-ray equipment for medical terminology and symbols
YY/T 0291-2007 medical X-ray equipment environmental requirements and test methods
3 Terms and Definitions
GB/T 10149 and as defined in the following terms and definitions apply to this document.
3.1 X-ray image intensifier television system
X-ray image intensifier, an optical camera, the image display system of the X-ray pattern can be converted into the corresponding visible Imaging system.
Note 1. On the physical implementation of the circuit component analog signal processing can be installed in the camera to be installed in the video display system.
3.2 Automatic brightness control
When the thickness of the different parts of the patient or of different irradiation, to obtain a constant monitor measures the brightness of the image taken.
3.3 Image brightness stabilization signal
X-ray image intensifier television system for controlling the output of the X-ray generator, the X-ray imaging system in different parts of the patient
X-ray image intensifier output screen brightness or change the monitor screen brightness control signal is obtained when the irradiation position or a different thickness.
3.4 The focal plane distance
X-ray tube focus to the X-ray image intensifier device from the plane of incidence. Unit mm.
3.5 Entrancefieldsize entrance field size
For the X-ray image intensifier television system, X-ray image intensifier entrance surface at a predetermined distance below the focal plane can be used to transmit X
......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 18 pages — is available in the English PDF.
Referenced standards
Normative references
Similar standards
Editions of YY/T 0608
| Edition | Title | Revision | Status |
|---|---|---|---|
| YY/T 0608-2013 | General specifications for X-ray image intensifier TV system for medical diagnosis | current edition | Current |
| YY/T 0608-2007 | General specifications for X-ray image intensifier TV system for medical diagnosis | previous edition | Superseded |
This page sells the current edition, YY/T 0608-2013. Earlier editions are listed for reference only.
How to Download YY/T 0608-2013
- 1
Add to cart
Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.
- 2
Checkout
Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).
- 3
Instant delivery (0–9 sec)
Delivery is automatic: within seconds of payment you'll receive an email with a secure download link. The link stays valid for 72 hours.
- 4
Invoice included
A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.
Related Standards
GB/T 10149-1988 — Terminology and symbol for medical X-ray equipment
YY/T 0291-2007 — Environmental requirements and test methods for medical X-ray equipment
YY/T 0297-2026 — General requirements for clinical investigation of medical devices
Secure payment via Stripe
Payments accepted
YY/T 0608-2013
$315.00