GB/T 3650-2008The general rules for inspection packing,storing transportation, marking and certification of ferroalloy (English PDF)

Foreword

This standard replaces GB/T 3650-1995 "The general rules for inspection, packing, storing transportation, marking and certification of ferroalloy".

Compared with GB/T 3650-1995, the main changes in this standard are as follows:

--- A foreword is added to the standard;

--- Some ferroalloy products and the elements that must be measured in Table 1 are adjusted;

--- The contents of marks and labels are supplemented;

--- A part of the content of the quality certificate is modified.

1 Scope

This standard specifies the acceptance inspection, packing, storage, transportation, marking, and quality certificate of ferroalloy.

This standard applies to the delivery of ferroalloy products.

2 Normative references

The provisions in the following documents become the provisions of this standard through reference in this standard. For the dated references, the subsequent amendments (excluding corrections) or revisions do not apply to this Part, however, parties who reach an agreement based on this standard are encouraged to study if the latest versions of these documents are applicable. For undated references, the latest edition of the referenced document applies to this standard.

GB/T 1250 Rules for expression and judgment of limiting values

3 Acceptance inspection

3.1 The technical requirements of ferroalloy products shall comply with the provisions of the corresponding standards, and the elements that must be measured for each product shall comply with the provisions of Table 1. If the buyer has special requirements, the supplier and the buyer shall negotiate separately.

3.2 Ferroalloy products shall be strictly finished, and the surface and section shall not have non-metallic inclusions that are visible to the eyes, but a small number of slag inclusions and ingot mold coatings are allowed to exist.

3.3 The buyer can re-inspect the quality of ferroalloy products according to the corresponding standards. If there is any objection, it shall be raised within 30 days of arrival. In principle, the product is not allowed to be used before the re-inspection.

When there is any objection to the delivery batch, the supply and demand parties shall arbitrate according to the relevant national standards for ferroalloy products. If there is no corresponding national standard, the arbitration shall be stipulated according to the agreement between the supplier and the buyer. […]