GB/T 28535-2018Separators for lead—acid batteries (English PDF)

Foreword

This standard was drafted in accordance with the rules given in GB/T 1.1-2009.

This standard replaces GB/T 28535-2012 "Lead-acid battery separator", compared with GB/T 28535-2012, the main technical content changes The following is as follows.

--- Revised the scope of application of the standard (see Chapter 1);

--- Removed the technical requirements and test methods for microporous rubber separators and meltblown polypropylene separators (see Chapter 1, Chapter 5, Chapter 2 of the 2012 edition) Chapter 6);

--- Increased the definition of defects, elongation at break, wet pressure holding capacity, ignition loss, puncture strength and related technical requirements and Test indicators (see Chapters 3, 5, and 6).

1 Scope

This standard specifies the classification and naming, marking, requirements, determination methods, inspection rules, and lead-acid battery separators (hereinafter referred to as "separators"). Marking, packaging, transportation, storage, etc.

This standard applies to ultra-fine glass fiber separators for lead-acid batteries, microporous polyethylene separators, sintered polyvinyl chloride separators.

2 Normative references

The following documents are indispensable for the application of this document. For dated references, only dated versions apply to this document. For undated references, the latest edition (including all amendments) applies to this document.

Standard environment for GB/T 2918 plastic sample conditioning and testing

GB/T 14436 General Rules for Industrial Product Assurance Documents

3 Terms and definitions

The following terms and definitions apply to this document.