Valid

GB/T 18147.1-2008Test method for hemp fibre - Part 1: Test method for oil content of hemp fibre (English PDF)

大麻纤维试验方法 第1部分:含油率试验方法

Preview PDF

This is a limited preview

Buy now to download the full PDF (8 pages)

Need quotation for your management?

Get a formal quotation for GB/T 18147.1-2008 in 30 minutes.

Issued by

General Administration of Quality Supervision, Inspection and Quarantine of the People's Republic of China; Standardization Administration of China

Level / Type

National · Recommended

Issue date

June 17, 2008

Implementation date

September 1, 2008

Scope

GB/T 18147.1-2008 is the English-translated version of 大麻纤维试验方法 第1部分:含油率试验方法.

GB/T 18147.1-2008 is the Chinese standard "Test method for hemp fibre - Part 1: Test method for oil content of hemp fibre". Its scope clause reads: This Part of GB/T 18147 specifies the test method for the oil content of hemp fiber.

This part applies to This part applies to raw white degummed hemp, raw white hemp sliver, raw white hemp noil. Its clauses include terms and definitions; principle; apparatus and reagents; sampling; procedure.

Found what you need?

Document preview — GB/T 18147.1-2008

National Standard of the People's Republic of China

ICS
59.060.10
Classification
W30

Issued by: General Administration of Quality Supervision, Inspection and Quarantine of the People's Republic of China; Standardization Administration of China

Contents

  • Foreword3
  • 1 Scope4
  • 2 Normative references4
  • 3 Terms and definitions4
  • 4 Principle5
  • 5 Apparatus and reagents5
  • 6 Sampling5
  • 7 Procedure5
  • 8 Results6
  • 9 Test report6

1 Scope

This Part of GB/T 18147 specifies the test method for the oil content of hemp fiber.

This part applies to This part applies to raw white degummed hemp, raw white hemp sliver, raw white hemp noil.

2 Normative references

The provisions in following documents become the provisions of this Part through reference in this Part of GB/T 18147.For the dated references, the subsequent amendments (excluding corrections) or revisions do not apply to this Part; however, parties who reach an agreement based on this Part are encouraged to study if the latest versions of these documents are applicable. For undated references, the latest edition of the referenced document applies.

GB/T 8170 Rules of rounding off for numerical values & expression and judgement of limiting values

GB/T 18146.1 Hemp fibre - Part 1.Raw white degummed hemp

GB/T 18146.2 Hemp fibre - Part 2.Raw white hemp sliver

GB/T 18146.3 Hemp fibre - Part 3.Raw white hemp noil

3 Terms and definitions

The following terms and definitions apply to this Part of GB/T 18147.

3.1 Oil content

The percentage of the mass of oil contained in the emulsion applied to the hemp fiber, as relative to the dry mass of the oil-containing hemp fiber.

4 Principle

Extract the oil and grease contained in the test specimen using a solvent; weigh the dry masses of the degreased fiber and the extracted oil/grease separately; calculate the oil content.

5 Apparatus and reagents

a) Soxhlet extractor;

b) Constant-temperature water bath. Temperature control deviation ±1 °C;

c) Drying oven. Temperature control range 50 °C ~ 150 °C, temperature control deviation ±1 °C;

d) Balance. Sensibility 0.01 g, 0.1 mg;

e) Desiccator. phi180 mm, phi150 mm;

f) Weighing bottle. phi40 mm × 70 mm;

g) Petroleum ether. Boiling range 60 °C ~ 90 °C;

h) Ethanol. Analytical grade;

i) Diethyl ether. Analytical grade;

j) Tweezers, scissors, etc.

6 Sampling

Sampling of raw white degummed hemp, raw white hemp sliver, raw white hemp noil shall be conducted in accordance with GB/T 18146.1, GB/T 18146.2, GB/T 18146.3, respectively. Three test specimens shall be taken for each sample; two shall be used for testing and one retained as a reserve. Each specimen shall weigh 5.00 g ± 0.20 g.

7 Procedure

7.1

Clean the distillation flask of the Soxhlet extractor; dry it to constant mass at 105 °C

~ 110 °C; cool it to room temperature in a desiccator; weigh it; record the mass as m1.

7.2

Wrap the specimen in filter paper to form a cylinder; place it in the extractor; add

150 mL of diethyl ether or 150 mL of a petroleum ether-ethanol mixture (petroleum ether + ethanol = 2 + 1). The height of the specimen shall be at least 10 mm below the

FZ/T 30003-2024 | GB/T 16984-2023 | GB/T 18147.2-2008 | GB/T 18147.6-2015 | […]

......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 8 pages — is available in the English PDF.

Referenced standards

Similar standards

Editions of GB/T 18147.1

EditionTitleRevisionStatus
GB/T 18147.1-2008Test method for hemp fibre - Part 1: Test method for oil content of hemp fibrecurrent editionCurrent
GB/T 18147.1-2000Test method for hemp fibre-Part 1:Test method for oil content in hemp fibreprevious editionSuperseded

This page sells the current edition, GB/T 18147.1-2008. Earlier editions are listed for reference only.

How to Download GB/T 18147.1-2008

  1. 1

    Add to cart

    Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.

  2. 2

    Checkout

    Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).

  3. 3

    Instant delivery (0–9 sec)

    Delivery is automatic: within seconds of payment you'll receive an email with a secure download link. The link stays valid for 72 hours.

  4. 4

    Invoice included

    A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.

Related Standards

English PDF
8 pages
Instant delivery (0–9 sec)
Invoice included
View Cart

Secure payment via Stripe

Payments accepted

VisaMastercardAmerican ExpressApple PayGoogle PayStripe

GB/T 18147.1-2008

$85.00