QC/T 791-2007Electric motorcycles and electric mopeds - Type approval test procedure (English PDF)

Foreword

The Appendix A of this Standard belongs to normative appendix.

1 Scope

This Standard specifies the contents required by the implementation conditions, test items, test methods, evaluation basis, test procedures and test report for the new product design type test of electric motorcycles and electric mopeds.

This Standard is applicable to electric motorcycles and electric mopeds (see GB/T 24158-2009 for the definitions) (Unless otherwise specified, they are referred to as electric motorcycles).

2 Normative References

The provisions in following documents become the provisions of this Standard through reference in this Standard. For dated references, the subsequent amendments (excluding corrigendum) or revisions do not apply to this Standard, however, parties who reach an agreement based on this Standard are encouraged to study if the latest versions of these documents are applicable. For undated references, the latest edition of the referenced document applies.

GB/T 4094.2 Electric Vehicles - Symbols for Controls, Indicators and Tell-Tales

GB/T 5374 Test Method of Reliability for Motorcycles and Mopeds

GB/T 18387 Limits and Test Methods of Magnetic and Electric Field Strength from Electric Vehicles Broadband 9khz to 30mhz

GB 24155 Electric Motorcycles and Electric Mopeds - Safety Specifications

GB/T 24156 Electric Motorcycles and Electric Mopeds - Power Performance - Test Methods

GB/T 24157 Electric Motorcycles and Electric Mopeds - Energy Consumption and Range - Test Procedures

GB/T 24158 Electric Motorcycles and Electric Mopeds - General Specifications The mandatory standards referenced in this Standard can refer to Appendix A.

3 Implementation Conditions

3.1 The manufacturer is required to provide the following documents.

a) Product enterprise standards including product technical conditions and specifications;

3.2 The tested vehicle shall meet the requirements of design drawings and technical documents approved by prescribed procedures.

3.4 The organization which undertakes the test shall prepare the test program as per the provisions of this Standard.

During the test period, if any of the following circumstances occur, the test shall be terminated in advance.

3.5 During the test period, maintain the vehicle as per the provisions of use instructions.

3.6 After the completion of the test, the test organization shall issue the test report as per the provisions of Chapter 6.

4 Test Items, Test Methods and Evaluation Basis

4.1 The type test consists of three parts, i.e. mandatory standards specified item test, entire-vehicle performance test, and reliability test.

4.2 Mandatory standards specified item test. It contains all compulsory motorcycle test items stipulated in the standards listed in Appendix A. the symbols for controls, indicators, and telltales shall be inspected as per the requirements of GB/T 4094.2.

4.4 Reliability test. The entire-vehicle reliability test shall be performed as per the method specified in 6.4.18 of GB/T 24158-2009; the test results shall meet the requirements specified in 5.2.18 of GB/T 24158-2009.

5 Test Procedures

The type test shall be performed in the following procedures.

6 Test Report

The test report shall contain the following contents. […]

Appendix A (Normative) Motorcycle Mandatory Inspection Standard List

GB 5948 Photometric Characteristics of Motorcycle Headlamps Equipped with […]