QC/T 603-2022Clips - Type A (English PDF)

Foreword

This document was in accordance with the requirements of GB/T 1.1-2020 "Directives for standardization - Part 1: Rules for the structure and drafting of standardizing documents".

This document replaces QC/T 603-1999 "A-type clips". Compared with QC/T 603-1999, it mainly adds:

- Provisions on the insertion force and withdrawal force of the clip (see Table 2);

- Provisions on general tolerances (see table 2);

- Aging requirements (see Table 2);

- Requirements for prohibited substance (see Table 2);

- Requirements for volatile organic compound (VOC) (see Table 2);

- Requirements for combustion characteristics (see Table 2);

- Provisions on acceptance quality limit (AQL) (see Table 2).

1 Scope

This document specifies the type, size, and technical conditions of A-type clips for automobiles.

This document is applicable to A-type clips, which have a diameter of D0 = 5 mm and D0 = 6 mm in the mounting hole of the body sheet, AND a maximum connection thickness S of 5 mm.

2 Normative references

The contents of the following documents constitute the essential provisions of this document through normative references in the text. Among them, for dated references, only the version corresponding to the date is applicable to this document; for undated references, the latest version (including all amendments) is applicable to this document.

GB/T 90.1-2002 Fasteners - Acceptance inspection

GB/T 90.2-2002 Fasteners - Marking and packaging

GB 8410 Flammability of automotive interior materials

GB/T 30512 Requirements for prohibited substances on automobiles

QC/T 15 General test method for automobile plastic products

QC/T 326 Coding rules for automotive standardized parts

QC/T 29017 Automotive molded plastic parts without individual tolerance limit the size of the deviation

3 Terms and definitions

This document does not have terms and definitions that need to be defined.

4 Types and sizes

See Figure 1 for the type and size of A-type clip. See Table 1 for relevant data and tolerance requirements. […]