GB/Z 6113.205-2013Specification for radio disturbance and immunity measuring apparatus and methods - Part 2-5: In situ measurements of disturbing emissions produced by physically large equipment (English PDF)

Foreword

GB /Z 6113 "radio disturbance and immunity measuring equipment and measurement methods" is divided into the following sections.

--- Part 1. Radio disturbance and immunity measuring equipment;

--- Part 2. Radio disturbance and immunity measurement methods;

--- Part 3. Radio disturbance and immunity measurement technical report;

--- Part 4. Uncertainty, statistics and limit modeling.

Among them, part 2 GB /Z 6113.205 "radio disturbance and immunity measuring equipment and measurement methods specification radio disturbance and resistance Interference measurement method "is divided into the following sub-part.

--- Part 2-1. Conducted disturbance measurements;

--- Part 2-2. Harassment power measurement;

--- Part 2-3. Radiation Harassment Measurement;

--- Part 2-4. Immunity measurement;

--- Part 2-5. Large-scale equipment harassment launch site measurement.

This section GB /Z 6113.205 Part 2-5.

This section drafted in accordance with GB/T 1.1-2009 given rules.

This section uses the translation method identical with the International Electrotechnical Commission IEC /CISPR/T R16-2-5.2008 "radio disturbance and immunity Part 2-5 of Specification for Measurement Equipment and Methods of Measurement. Large Equipment Harassment Emission Field Measurement. "

This section also made the following editorial changes.

--- According to the international standards foreword and the introduction of the content, reorganization and preparation of the foreword of this section, canceled the introduction;

--- In Chapter 2, "Normative references", add the following references. GB/T 4365-2003 "Electrotechnical terminology Electromagnetic Content "

--- Due to the definition of IEC /CISPR/T R16-2-5.2008 3.3 "characterisedinterference" is not followed in this section Mentioned, so delete the definition, followed by all the definition of terms in turn re-ordered.

1 Scope

GB /Z 6113 provisions of this part of the large-scale equipment and systems (excluding networks) in any environment on-site measurement of electromagnetic disturbance method.

This section covers radiation emission and conducted emission measurements, not including immunity test.

This section mainly applies to those who are not existing emission standards (such as GB 4824 and GB 9254) within the scope of large-scale equipment. it is just As a guideline on how to deal with the measurement of installations installed in a particular place, no emission requirements are specified.

Note 1. This guidance document is intended for use in equipment that is not covered by the existing emission standard but may also be used in certain instances for the purpose of implementing various types of equipment Field testing of equipment provides additional information.

Note 2. Large equipment refers to such as production equipment, conveyors, large displays, flight simulators, traffic control equipment.

However, the use of representative large equipment and the specific operating environment were severely affected by the environmental conditions at the time of measurement, Calculated in the type test program using this measurement.

Note 3. In general, type tests on large equipment are carried out only in controlled environments at standard test sites. The results obtained under field conditions are only valid for each The actual measurement of a large stand-alone unit at its specific installation site is valid. These results for the same type, but installed in different places of other equipment Not applicable.

This section gives the reference distance measured at the site, so that the measurement results can be compared with the existing relevant standards.

This section applies to the frequency range of 9kHz ~ 18GHz.

The biological effects of living organisms are beyond the scope of this section.

2 Normative references

The following documents for the application of this document is essential. For dated references, only the dated version applies to this document. For undated references, the latest edition (including all amendments) applies to this document.

GB/T 4365-2003 Electrotechnical terminology Electromagnetic compatibility (IEC 60050 (161) .1990, IDT)

GB/T 6113.101-2008 Radio disturbance and immunity measuring apparatus and methods - Part 1-1. Radio disturbance And Immunity Measuring Equipment Measuring Equipment (IEC /CISPR 16-1-1.2006, IDT)

GB/T 6113.102-2008 Radio disturbance and immunity measuring apparatus and methods - Part 1-2. Radio disturbance And Immunity Measuring Equipment Auxiliary Equipment Conducted Harassment (IEC /CISPR 16-1-2.2006, IDT)

GB/T 6113.104-2008 Specification for radio disturbance and immunity measuring apparatus and methods - Part 1-4 - Radio disturbance And Immunity Measuring Equipment Auxiliary Equipment Radiation Harassment (IEC /CISPR 16-1-4.2005, IDT)

GB/T 6113.201-2008 Radio disturbance and immunity measuring apparatus and methods - Part 2-1. Radio disturbance And Immunity Measurement Methods Conducted Harassment Measurements (IEC /CISPR 16-2-1.2003, IDT)

GB/T 6113.203-2008 Radio disturbance and immunity measuring apparatus and methods - Part 2-3. Radio disturbance And Immunity Measurement Methods Radiation Harassment Measurement (IEC /CISPR 16-2-3.2003, IDT)

Note: See references.