GB/T 8894-2014Copper and copper-alloy waveguide tube (English PDF)

Foreword

This standard is in accordance with GB/T 1.1-2009 given rules drafted.

This standard replaces GB/T 8894-2007 "copper and copper alloy waveguide." This standard compared with GB/T 8894-2007, mainly like Under changes.

--- Increased TU00, TU0, BMn40-1.5 three alloy grades and the corresponding technical requirements;

--- Rectangular waveguide increases R900, R740, R620 three models and the appropriate technical requirements;

--- Flat rectangular waveguides increases the model M12, and an increase in the corresponding technical requirements;

--- Models R120, R100, R84, R70, R58, R48 rectangular waveguide bore fillet radius r1 revised to 0.6 from 0.8;

--- Rectangular waveguide bore size tolerances canceled II grade;

--- Model R32 increased wall thickness specifications, increasing the wall thickness from the original specifications 3.00,4.00,5.00,6.00 2.030 and the corresponding technical requirements;

--- Tubing "eccentricity", technical specifications redefined, accuracy is improved;

--- The pipe length to allow deviation and re-cut the slope provides accuracy is improved;

--- The "verticality" to "squareness";

--- Add "pull aside stress relief (HR50)" status.

1 Scope

This standard specifies the copper and copper alloy waveguide requirements, test methods, inspection rules and signs, packaging, transportation, storage and quality certificates Books and contracts (or orders) content.

This standard applies to electronic, telecommunications and other industries manufacture of radio equipment and telecommunications equipment used in drawing a circle, rectangle, square and rectangular flat Copper and copper alloy shaped waveguide.

2 Normative references

The following documents for the application of this document is essential. For dated references, only the dated version suitable for use herein Member. For undated references, the latest edition (including any amendments) applies to this document.

GB/T 1031 Geometrical product specifications (GPS) Surface texture Profile method Surface roughness parameters and their values

GB/T 5121 (all parts) of copper and copper alloys - GB/T 5231 and processing of copper and copper alloy grades and chemical composition

GB/T 8888 heavy non-ferrous metal processing products, packaging, labeling, transportation and storage

GB/T 10567.2 copper and copper alloy processing material residual stress - Ammonia test test method

GB/T 26303.1 copper and copper alloy processing material Dimensions detection methods - Part 1: Pipes

YS/T 335 oxygen free copper metallurgical test method

YS/T 482 copper and copper alloy analysis photoemission spectroscopy

YS/T 483 copper and copper alloy analysis X-ray fluorescence spectrometry (wavelength dispersion)

YS/T 668 copper and copper alloy physical and chemical detection sampling method

3 Terms

The following terms and definitions apply to this document.

4 Requirements