GB/T 5382-2008Performance and measurement method for braking force of motorcycles and mopeds (English PDF)

3.1

Generated by the brake, forcing the wheel speed or to reduce friction locking.

3.2

Vehicle curb weight plus a driver before and after the axle load borne.

4.1

Before motorcycles and mopeds, the rear axle braking force shall not be less than the limits listed in Table 1.

Table 1 braking force limit

Moped Motorcycle

Front axle rear axle front axle rear axle

60% of the axle load axle load 50% 60% 55% axle load axle load a a tricycle calculated according to the dynamic axle load plate brake tester when testing.

4.2

brake control force limits should be met.

a) a motorcycle, sidecar motorcycles and mopeds, pedal operating force should not exceed 350N, hand control force no greater than

200N;

b) three-wheeled motorcycles, pedal control force no greater than 500N, hand control force no greater than 200N.

4.3 three-wheeled motorcycle braking force balance requirements

an increase in braking force during the whole simultaneously measured left and right wheel braking force difference between the maximum value,

And the whole process measured in the left and right wheel axle maximum braking force is greater than the on the front axle should not exceed 20% of the rear axle braking force according to 5.3.9 […]