GB/T 5359.3-2008Term for motorcycles and mopeds - Part 3: Dimensions of vehicle with two and three wheels (English PDF)

1 Scope

GB/T 5359 provisions of this part of the general principles and terminology of motorcycles and related to the size.

This section applies to quasi GB/T 5359.1 defined motorcycles and mopeds (hereinafter referred to as "vehicle").

2 Normative references

The following documents contain provisions which, through reference to GB/T 5359 to the present, constitute provisions of this section. For dated reference documents

Member, all subsequent amendments (not including errata content) or revisions do not apply to this section, however, encouraged to reach under this section

Parties to research agreement to use the latest versions of these documents. For undated reference documents, the latest versions apply to this section.

GB/T 5359.1 motorcycles and mopeds term vehicle type

3 General Principles

Unless otherwise specified, the default.

a) a support surface of the vehicle is horizontal, length and width in the horizontal plane, the vertical height of the plane;

b) the quality of the vehicle means the vehicle dry mass;

c) tire inflation pressure should reach agreement with the technical documentation specified by the vehicle manufacturer;

d) the vehicle is stationary, upright position. Engine is not running. The wheels of the vehicle straight-ahead position. Tricycle doors and windows closed;

Note. This does not apply to 4.3.2,4.3.3.

e) "vehicle" means the manufacturer according to standard assembly of new vehicles;

Wheel f) of the vehicle resting on a support surface;

g) "wheel center plane" means the plane of symmetry of the inside edge of the rim two;

h) "wheel center" means the center of the wheel plane and the wheel rotating shaft centerline intersection.

4 Terms and Definitions

GB/T 5359.1 and established the following terms and definitions apply to this section.