GB/T 43866-2024Inspection method for equipping rate of energy measuring instrument for enterprises (English PDF)

Foreword

This document is in accordance with the provisions of GB/T 1:1-2020 "Guidelines for standardization work Part 1: Structure and drafting rules for standardization documents" Drafting:

Please note that some of the contents of this document may involve patents: The issuing organization of this document does not assume the responsibility for identifying patents:

This document is proposed and coordinated by the National Committee for Standardization of Metrology Instruments (SAC/TC525):

This document was drafted by: Ningbo Metrology and Testing Institute, Zhejiang Metrology Science Institute, Fujian Metrology Science Institute, Zhejiang University Ningbo Poland Institute of Technology, Shenyang Institute of Metrology and Testing, Hangzhou Ruichuang Energy Technology Co:, Ltd:, and China University of Metrology:

The main drafters of this document are: Qian Hao, Yu Shifan, Wu Menghui, Hu Changxing, Yu Xiaobing, Xu Guosheng, Zhou Jinlong, Huang Zhenwei, Ma Jun, Lu Xiaofeng, Wang Wenlin, Wu Huanfen, Zhang Yupei, Wang Yimin, Zhan Zhijie, and Li Zhangbiao:

Inspection Methods for the Equipping Rate of Energy Metering Instruments in Enterprises

1 Scope

This document provides the principles for determining the quantity of energy metering equipment to be equipped, as well as the inspection methods and procedures:

This document is applicable to the inspection of the energy metering equipment ratio of enterprises, and other energy-consuming units can refer to it when conducting energy metering equipment ratio inspection: use:

2 Normative references

GB/T 2589

GB 17167-2006

GB/T 23331

GB/T 33656

3 Terms and definitions

The terms and definitions defined in GB 17167-2006, GB/T 2589, GB/T 23331, GB/T 33656 and the following terms and definitions apply to this document: 3:1 Main production systemmainproductionsystem A complete system consisting of production process, devices, facilities and equipment determined by the direct production of products: 3:2 Processes, facilities and equipment serving major production systems:

Note: Includes power supply, machine repair, water supply, gas supply, heating, refrigeration, lighting, warehouses and raw material sites within the factory, as well as safety and environmental protection devices and facilities: 3:3 Production command systems and service departments that are not directly involved in production but are closely connected with the main production systems and auxiliary production systems:

4 Principles for determining the quantity of equipment

4:1 Principles for determining theoretical requirements 4:1:1 Compliance Select energy metering points based on the energy management requirements of the country and energy-consuming units: