Valid

GB/T 36922-2018Determination of organophosphorous flame retardants in toys—Gas chromatography-mass spectrography method (English PDF)

玩具中有机磷阻燃剂含量的测定 气相色谱-质谱联用法

Preview PDF

This is a limited preview

Buy now to download the full PDF (15 pages)

Need quotation for your management?

Get a formal quotation for GB/T 36922-2018 in 30 minutes.

Issued by

SAMR; SAC

Level / Type

National · Recommended

Issue date

December 28, 2018

Implementation date

December 28, 2018

Scope

GB/T 36922-2018 is the English-translated version of 玩具中有机磷阻燃剂含量的测定 气相色谱-质谱联用法.

GB/T 36922-2018 is a gas chromatography-mass spectrometry method for determining three organophosphorus flame retardants in toys: tris(2-chloroethyl) phosphate (TCEP), tris(1,3-dichloroisopropyl) phosphate (TDCP) and tris(2-chloro-1-methylethyl) phosphate (TCPP).

It applies to the polymer materials used in toys. The sample is extracted with toluene in a Soxhlet extractor, the extract is brought to volume and analysed by GC-MS in selected ion monitoring mode, and the result is quantified by the external standard method.

The standard sets out the reagents and instruments, the analysis steps and GC-MS conditions, the calculation of the content in mg/kg, a lower limit of quantitation of 1 mg/kg, a required recovery of 85% to 110%, the precision and the test report. It was issued on 28 December 2018 and has applied since 28 December 2018.

Found what you need?

Document preview — GB/T 36922-2018

National Standard of the People's Republic of China

ICS
97.200.50
Classification
Y 57

Issued by: State Administration for Market Regulation; Standardization Administration of the PRC

Contents

  • Foreword3
  • 1 Scope4
  • 2 Principle4
  • 3 Reagents and materials4
  • 4 Instruments and devices5
  • 5 Analysis steps5
  • 6 Result calculation8
  • 7 Lower limit of quantitation, recovery rate and precision8
  • 8 Test report9
  • Annex A (informative) Chromatogram of organic phosphorus flame retardant10
  • Annex B (informative) Precision11
  • Bibliography12

1 Scope

This Standard specifies gas chromatometry-mass spectrometry method for three organic phosphorus flame retardants: tris(2-chloroethyl) phosphate (TCEP), tris(1,3-dichloroisopropyl) phosphate (TDCP) and tris(2-chloro-1-methylethyl) phosphate (TCPP) in toys.

This Standard is applicable to determination of organic phosphorus flame retardant in polymer materials in toys.

2 Principle

Use toluene to extract TCEP, TDCP and TCPP in the sample in Soxhlet extractor. After setting the volume of the extract, use gas chromatography-mass spectrometry (GC-MS) to determine. Use external standard method to quantify.

3 Reagents and materials

3.1 Toluene.

3.2 TCEP standard product: purity is not less than 97%.

3.3 TDCP standard product: purity is not less than 97%.

3.4 TCPP standard: purity not less than 95%.

3.5 Standard stock solution: Accurately weigh TCEP standard products (see 3.2), TDCP standard products (see 3.3) and TCPP standard products (see 3.4). Use toluene (see 3.1) to prepare 1000mg/L stock solution. […]

5 Analysis steps

5.4 Gas chromatometry-mass spectrometry method

5.4.1 GC-MS determination conditions

Different GC-MS has different analysis parameters. The set parameters shall ensure that the measured component can be effectively separated from other components during the measurement. The following parameters are one of the GC-MS measurement conditions:

a) Chromatography column: HP-5MS column, 30m×0.25mm×0.25µm, or equivalent;

b) Inlet temperature: 300°C;

c) Chromatography-mass spectrometer interface temperature: 280°C;

d) Sampling method: pressure-splitless injection. Apply a pressure of 344.75kPa. Open the valve after 1.0min;

e) Carrier gas: helium, purity >=99.999%; control mode: constant flow; flow rate: 1.8mL/min;

f) Temperature programming: After maintaining at 80°C for 2min, raise to 160°C at 20°C/min. Maintain 1min. Then raise to 320°C at 40°C/min. Maintain 2min;

g) Injection volume: 1µL;

h) Ion source: EI source;

i) Ionization energy: 70eV;

j) Scanning method: Select ion monitoring (SIM);

k) Quadrupole temperature: 150°C;

l) Ion source temperature: 230°C;

m) Solvent delay time: 3min.

The chromatogram of each standard under the above measurement conditions […]

6 Result calculation

If it is determined that TCEP, TDPP, and TCPP are present, perform external standard quantitative analysis based on the extracted ion chromatographic peak area. The content of TCEP, TDPP and TCPP in the sample is calculated according to formula (1):

Where,

Xi - The content of organic phosphorus flame retardant in the sample, in milligrams per kilogram (mg/kg);

CS - The concentration of organic phosphorus flame retardant in the test solution, in milligrams per liter (mg/L);

V - The set volume of toluene, in milliliters (mL);

D - The dilution factor;

m - The mass of test material, in grams (g).

Calculate the concentration of organic phosphorus flame retardant in the sample according to the above formula. If the test response value of the test solution exceeds the linear range, it shall be appropriately diluted and measured. The result is kept to one decimal place.

7 Lower limit of quantitation, recovery rate and precision

7.1 Lower limit of quantitation

The three organic phosphorus flame retardant methods have a lower limit of 1mg/kg.

7.2 Recovery rate

Quantitatively add an appropriate standard solution of known concentration to the sample. Perform recovery rate analysis according to the above test steps 5.2~5.4. The recovery rate of TCEP, TDPP and TCPP in the polymer shall be 85%~110%. […]

......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 15 pages — is available in the English PDF.

Similar standards

How to Download GB/T 36922-2018

  1. 1

    Add to cart

    Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.

  2. 2

    Checkout

    Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).

  3. 3

    Fast delivery

    After payment you'll receive an email confirmation. The English PDF is sent to the same address, usually within minutes and at the latest within 1 business day.

  4. 4

    Invoice included

    A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.

Related Standards

English PDF
15 pages
Fast delivery
Invoice included
View Cart

Secure payment via Stripe

Payments accepted

VisaMastercardAmerican ExpressApple PayGoogle PayStripe

GB/T 36922-2018

$125.00