GB/T 24318-2009Determination of total nitrogen content in animal feeding stuffs by combustion according to the dumas principle and calculation of the crude protein content (English PDF)
杜马斯燃烧法测定饲料原料中总氮含量及粗蛋白质的计算
This is a limited preview
Buy now to download the full PDF (16 pages)
Need quotation for your management?
Get a formal quotation for GB/T 24318-2009 in 30 minutes.
Issued by
SAMR; SAC
Level / Type
National · Recommended
Issue date
September 30, 2009
Implementation date
December 1, 2009
Scope
GB/T 24318-2009 is the English-translated version of 杜马斯燃烧法测定饲料原料中总氮含量及粗蛋白质的计算.
GB/T 24318-2009 is the Chinese standard "Determination of total nitrogen content in animal feeding stuffs by combustion according to the dumas principle and calculation of the crude protein content".
Its scope clause reads: This standard specifies the total nitrogen content of the feed ingredients Dumas combustion method for the determination. This standard applies to the determination of crude protein content and total nitrogen content of the feed ingredients single calculation, the detection limit was 0.1mg. Its clauses include terms and definitions; reagents.
Found what you need?
Document preview — GB/T 24318-2009
National Standard of the People's Republic of China
- ICS
- 65.120
- Classification
- B 46
Issued by: State Administration for Market Regulation; Standardization Administration of the PRC
Contents
- Introduction
- 1 Scope
- 2 Normative references
- 3 Terms and definitions
- 3.1 total nitrogen content
- 4 Principle
- 5 Reagent
- 5.1 1 carrier gas
- 5.2 Combustion gas
- 5.3 oxidizer
- 5.4 reductant
- 5.5 Adsorbent
- 5.6 standard
- 6 Instrument
- 6.1 Analytical Balance
- 6.2 Sample grinder or mortar
- 6.3 Sample screen
- 6.4 square piece of tin foil, a nitrogen-free paper or tin capsules
- 6.6 power supply
- 7 Sampling and Sample Preparation
- 7.1 Sample
- 7.2 Sample Preparation
- 8.1 Calibration
- 8.2 Test Sample
- 8.3 Determination of
- 9 3 Calculation Results
- 9.1 3 total nitrogen content
- 9.1.2 Analysis of concentration and drying process after total nitrogen content of the sample
- 9.3 The results are shown
- 10 Repeatability
- 11 Reproducibility
- Appendix A (informative) This standard reg number and ISO /FDIS16634.2005 (E) 4 control reg number
- Annex B (informative) This standard and ISO /FDIS16634.2005 (E) Technical Difference and Cause
- Annex C (informative) Basic Instrumentation Dumas Scheme
- Annex D (informative) protein Factor
- Annex E (informative) repeatability limit and reproducibility limit
- Annex F (informative) standard curve
1 Scope
This standard specifies the total nitrogen content of the feed ingredients Dumas combustion method for the determination.
This standard applies to the determination of crude protein content and total nitrogen content of the feed ingredients single calculation, the detection limit was 0.1mg.
2 Normative references
The following documents contain provisions which, through reference in this standard and become the standard terms. For dated references, subsequent
Amendments (not including errata content) or revisions do not apply to this standard, however, encourage the parties to the agreement are based on research
Whether the latest versions of these documents. For undated reference documents, the latest versions apply to this standard.
GB/T 14699.1 feed sampling (GB/T 14699.1-2005, ISO 6497.2002, IDT)
3 Terms and Definitions
The following terms and definitions apply to this standard.
3.1
Sample mass percentage of nitrogen.
3.2
The total nitrogen content multiplied by a conversion factor (see Appendix D), expressed as a percentage by mass.
Principle 4
Under aerobic conditions, the sample combustion tube combustion heating (about 900 °C), the interference component is generated to a range of appropriate absorbent
In addition, the nitrogen-containing substance in the sample is quantitatively converted into molecular nitrogen after a thermal conductivity detector.
5 Reagents
The reagents used in this standard, unless otherwise specified, were of analytical grade.
Different analytical instruments used in different reagents.
5.1 The carrier gas
Helium (99.99%) or carbon dioxide (99.99%).
5.2 Combustion gas
Oxygen (99.99%).
5.3 oxidants
Selecting (copper oxide, aluminum oxide, magnesium) according to the type of instrument.
5.4 reductant
Choose (copper, tungsten) according to the type of instrument.
5.5 Adsorbent
Choose (phosphorus pentoxide, magnesium perchlorate, solid, solid sodium carbonate) according to the type of instrument.
GB/T 23884-2021 | GB/T 23742-2009 | GB/T 23879-2009 | GB/T 19684-2026 | GB/T 13088-2026 | GB/T 10649-2025 | […]
......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 16 pages — is available in the English PDF.
Similar standards
How to Download GB/T 24318-2009
- 1
Add to cart
Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.
- 2
Checkout
Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).
- 3
Fast delivery
After payment you'll receive an email confirmation. The English PDF is sent to the same address, usually within minutes and at the latest within 1 business day.
- 4
Invoice included
A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.
Related Standards
GB/T 10003-2026 — Biaxially oriented polypropylene (BOPP) film
GB/T 10004-2026 — Plastic/Plastic laminated films and pouches for packaging
GB/T 10007-2026 — Rigid cellular plastics - Determination of shear properties
GB/T 24318-2009
$285.00