GB/T 15367-2008Motorcycles and mopeds part and component - Designations for vehicle with two and three wheels (English PDF)

1 Scope

This standard specifies the name of spare parts GB/T 5359.1 defined motorcycles and mopeds.

This standard applies to GB/T 5359.1 defined motorcycles and mopeds.

2 Normative references

The following documents contain provisions which, through reference in this standard and become the standard terms. For dated references, subsequent

Amendments (not including errata content) or revisions do not apply to this standard, however, encourage the parties to the agreement are based on research

Whether the latest versions of these documents. For undated reference documents, the latest versions apply to this standard.

GB/T 5359.1 motorcycles and mopeds term vehicle type

Names of Parts 3 engine powertrain

Names of Parts 3.1 engine powertrain portion of the heat engine shown in Table 1.

Table 1 engine powertrain component name part of the heat engine

No. Component Component Parts

1 cylinder head (head)

Valve guides, cylinder head, cylinder head (head) casing, into the (row) Valve

Seats, valve covers, cylinder head (head) gaskets, cylinder head (head) side cover

2 cylinder cylinder block, cylinder liner, cylinder block gasket

3 Crankshaft - connecting rod

Crank, crank pin, connecting rod, connecting rod bearings, crankshaft balancer, balancer

Driving gear, balancer driven gear

4 pistons, piston pins, piston pin retainer

5 Piston Ring

Oil ring combination blade, collar

Piston gas ring (1 ring, 2 rings)

Names of Parts 3.2 engine powertrain electronic control fuel injection system are shown in Table 2.

Table 2 engine powertrain component name electronically controlled fuel injection system

No. Component Component Parts

Electronically controlled fuel

Injection System

ECU system (ElectricalControlUnit)

Input circuit, output circuit, A/D converter, an actuator, a memory,

Central processor, input/output interface sensor

Pressure regulator

Throttle body

Tubing pressure tubing or pipe ordinary

Supply pump

Injector fuel filters, plug wires, solenoids, springs, armature, needle, needle shaft

Cold start injector needle valve, solenoids, power connector, spring, nozzle

Cold start switch power connector, a housing, a bimetal, heating coils, contacts […]