Valid

GB/T 13835.5-2009Test method for rabbit hair - Part 5: Breaking tenacity and elongation at break of single fibre (English PDF)

兔毛纤维试验方法 第5部分:单纤维断裂强度和断裂伸长率

Preview PDF

This is a limited preview

Buy now to download the full PDF (15 pages)

Need quotation for your management?

Get a formal quotation for GB/T 13835.5-2009 in 30 minutes.

Issued by

SAMR; SAC

Level / Type

National · Recommended

Issue date

April 23, 2009

Implementation date

September 1, 2009

Scope

GB/T 13835.5-2009 is the English-translated version of 兔毛纤维试验方法 第5部分:单纤维断裂强度和断裂伸长率.

GB/T 13835.5-2009 is the Chinese national method for measuring how much force a single rabbit hair fibre takes to break and how far it stretches before breaking.

It is Part 5 of the nine-part GB/T 13835 series on rabbit hair test methods and it reports the average breaking force and the average elongation at break of a sample.

It defines the terms it uses, among them coarse hair and fine hair, separated at a fibre diameter of 30 µm, breaking force in newtons or centinewtons, breaking tenacity in cN/dtex, elongation at break and gauge length.

Specimens are conditioned to GB/T 6529, sampled to GB/T 13835.1 and results rounded to GB/T 8170. It replaces GB/T 13835.5-1992, was issued on 23 April 2009 and has applied since 1 September 2009.

Found what you need?

Document preview — GB/T 13835.5-2009

National Standard of the People's Republic of China

ICS
59.060.01
Classification
W 20
Replacing
GB/T 13835.5-1992

Issued by: State Administration for Market Regulation; Standardization Administration of the PRC

Contents

  • Foreword
  • 1 Scope
  • 2 Normative references
  • 3 Terms and Definitions

Foreword

GB/T 13835 "rabbit fiber test method" consists of the following nine sections.

--- Part 1. Sampling;

--- Part 2. The average length and short hair ratio manual transmission method;

--- Part 3. impurity rate, coarse hair and loose hair rate;

--- Part 4. Regain oven method;

--- Part 5. single fiber breaking strength and elongation at break;

--- Part 6. diameter projection microscopy;

--- Part 7. whiteness;

--- Part 8. ether extract content;

--- Part 9. crimp performance.

This section GB/T 13835 Part 5.

This Part replaces GB/T 13835.5-1992 "rabbit single fiber breaking strength and elongation test methods." This section compared with the GB/T 13835.5-1992 The main changes are as follows.

--- Modify the terms and definitions (version 1992 Chapter 3; edition Chapter 3);

--- Remove traction isokinetic strength testing machine (CRT) and the use of standards related content (1992 version 3.5,6.1.1, 6.1.5 and 9.3.1);

--- Remove Appendix A (1992 edition Appendix A);

--- Remove the test sample hairs provisions (1992 version 9.4);

--- Modify the preset humidity, the humidity and atmospheric testing standards (Edition 1992 Chapter 5; Chapter 6 of this edition).

1 Scope

GB/T 13835 in this section specifies the method for the determination of single fiber breaking strength and elongation at break.

This section applies to the determination of the average rabbit single fiber breaking strength and average elongation at break.

2 Normative references

The following documents contain provisions which, through reference GB/T 13835 in this section constitute provisions of this section. For dated reference documents, all subsequent amendments (not including errata content) or revisions do not apply to this section, however, encouraged to reach under this section Research into whether the parties to the agreement to use the latest versions of these documents. For undated reference documents, the latest versions apply to this section.

GB/T 6529 Textiles Standard conditioning and testing atmosphere

GB/T 8170 repair value expressed about the rules and limit values and judgment

GB/T 13835.1 rabbit hair fiber test methods - Part 1: Sampling

3 Terms and Definitions

The following terms and definitions apply GB/T 13835 in this section.

3.1 Coarse hair

Diameter greater than or equal 30µm, and there are two or more myeloid without hair curly fur fibers.

3.2 Fine hair

Diameter of less than 30µm rabbit hair fibers.

3.3 Breaking force

Tensile test, the fibers resist the maximum force to fracture. Units Newtons (N) or PCT Newton (cN) represented.

3.4 Breaking tenacity

Fiber unit linear density (unstretched ago) breaking strength. Usually a combination of special units PCT Newton (cN/dtex) expressed per minute.

3.5 Elongation at break

Fiber that is stretched to the maximum load elongation at break.

3.6 Breaking elongation rate

Elongation at break of fiber samples before tensile elongation percentage.

3.7 Gauge length

The fiber tensile test specimens between the two clamp jaws (plus a predetermined pretension) length.

......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 15 pages — is available in the English PDF.

Referenced standards

Similar standards

Editions of GB/T 13835.5

EditionTitleRevisionStatus
GB/T 13835.5-2009Test method for rabbit hair - Part 5: Breaking tenacity and elongation at break of single fibrecurrent editionCurrent
GB/T 13835.5-1992Test method for rabbit hair - Part 5: Breaking tenacity and elongation at break of single fibreprevious editionSuperseded

This page sells the current edition, GB/T 13835.5-2009. Earlier editions are listed for reference only.

How to Download GB/T 13835.5-2009

  1. 1

    Add to cart

    Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.

  2. 2

    Checkout

    Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).

  3. 3

    Instant delivery (0–9 sec)

    Delivery is automatic: within seconds of payment you'll receive an email with a secure download link. The link stays valid for 72 hours.

  4. 4

    Invoice included

    A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.

Related Standards

English PDF
15 pages
Instant delivery (0–9 sec)
Invoice included
View Cart

Secure payment via Stripe

Payments accepted

VisaMastercardAmerican ExpressApple PayGoogle PayStripe

GB/T 13835.5-2009

$85.00