SN/T 5228.3-2019Rapid screening method for pathogenic microorganisms in exported foods MALDI-TOF MS method Part 3: Staphylococcus aureus (English PDF)

Foreword

SN/T 5228-2019 "The MALDI-TOF MS Method for Rapid Screening of Pathogenic Microorganisms in Exported Foods" is divided into 9 parts.

--Part 1: Vibrio alginolyticus;

--Part 2: Clostridium perfringens;

--Part 3: Staphylococcus aureus;

--Part 4: Cronobacterium;

--Part 5: Vibrio vulnificus;

--Part 6: Bacillus cereus;

--Part 7: Campylobacter jejuni;

--Part 8: Klebsiella pneumoniae;

--Part 9: Pseudomonas aeruginosa.

This part is part 3 of SN/T 5228-2019.

This part was drafted in accordance with the rules given in GB/T 1.1-2009.

This part is proposed and managed by the General Administration of Customs of the People's Republic of China.

Drafting organizations of this section. Beijing Customs of the People's Republic of China, Tianjin Customs of the People's Republic of China.

1 Scope

This part of SN/T 5228 specifies the MALDI-TOF MS rapid screening method for Staphylococcus aureus in exported food.

This section applies to the rapid screening of Staphylococcus aureus in export food.

2 Normative references

The following documents are indispensable for the application of this document. For dated reference documents, only the dated version applies to this article Pieces. For undated reference documents, the latest version (including all amendments) is applicable to this document.

GB 4789.10 National Food Safety Standard Food Microbiological Inspection Inspection of Staphylococcus Aureus GB/T 6682 Analytical laboratory water specifications and test methods GB 19489 Laboratory Biosafety General Requirements

3 Abbreviations

The following abbreviations apply to this document.

BTS. Bacteria detection standard).

CHCA. alpha-cyano-4-hydroxycinnamic acid).

MALDI-TOF MS. Matrix-assisted laser desorption ionization time-of-flight mass spectrometry.

4 Biosecurity measures

In order to protect the safety of laboratory personnel, qualified personnel should detect Staphylococcus aureus, all cultures and waste Discarded materials should refer to the relevant regulations in GB 19489.

5 Method summary

MALDI-TOF MS is a technology applied to the rapid detection of microbial whole cells, mainly based on the fingerprint analysis of microbial characteristic protein.

Complete the identification and classification of microorganisms. Place the sample of the colony to be identified and an appropriate amount of matrix solution on the sample plate, and form after the solvent volatilizes the co-crystallization of the sample and the matrix, the laser is used as the energy source to radiate the co-crystal, the matrix molecules absorb energy and desorb the sample and make the sample Product ionization, after the time-of-flight analyzer, separates the ions of different mass-to-charge ratios to form a microbial-specific mass spectrum. Will be tested Comparing the substance spectrum with the standard protein fingerprint database of known microorganisms, the species of microorganisms can be determined, and the species of microorganisms can be determined.

是identification.

6 Reagents and materials

Except for special instructions, all reagents are chromatographically pure reagents. The experimental water meets the requirements of first-grade water in GB/T 6682.

6.1 Blood agar plate.

6.2 Acetonitrile.

6.3 Absolute ethanol.

6.4 Formic acid.

6.5 Trifluoroacetic acid).

6.6 alpha-cyano-4-hydroxycinnamic acid (CHCA).

6.7 BTS standard product.

6.8 Solvent I. prepared according to the ratio of water. acetonitrile (6.2). trifluoroacetic acid (6.5) to 50.47.5.2.5 (volume ratio), now prepared Now use.

6.9 Preparation of BTS standard solution. Dissolve BTS standard (6.7) with 50 µL solvent I (6.8). Pipette repeatedly to dissolve BTS powder (avoid vigorous shaking), leave it at room temperature for 5 minutes, and then dissolve it again. After BTS (6.7) is completely dissolved, centrifuge it immediately and use 200 µL PCR tubes are aliquoted, 5 µL per tube, stored at -20°C for later use.

6.10 Preparation of CHCA matrix solution. Add solvent I (6.8) to CHCA (6.6) powder to make the final concentration of CHCA 10 mg/mL.

Shake and mix until the solution is clear. Use 1.5 mL centrifuge tubes for aliquots, 50 µL per tube, seal the mouth of the tube with a parafilm, and store at room temperature for later use.

After storage, if a large amount of precipitation occurs, it should be discarded.

7 Main instruments and equipment

7.1 Bench-top centrifuge. the maximum centrifugal force is >= 16 000 g.

7.2 Vortex oscillator.

7.3 Micro-adjustable pipettes and sterile tips. 2 µL, 100 µL,.200 µL, 1000 µL.

7.4 Matrix-assisted laser desorption ionization time-of-flight mass spectrometer.

8 Detection steps

9 Results judgment and report

9.1 The suspicious colony is identified as Staphylococcus aureus by MALDI-TOF MS, and the matching score is greater than or equal to 1.700, the test result can be determined If the result is suspicious, it should be confirmed and reported according to the method of GB 4789.10.

9.2 For results other than 9.1, the test result can be determined to be negative, and the report does not detect Staphylococcus aureus.

10 Waste treatment and pollution prevention measures

The waste in the testing process needs to be autoclaved at 121°C for at least 30 minutes before being disposed of.