SJ/T 11633-2016Supporting high-voltage bus capacitors selective specifications for electric vehicle motor controller (English PDF)

Foreword

This Standard was drafted in accordance with the rules given in GB/T 1.1-2009.

Attention is drawn to the possibility that some of the elements of this Standard

may be the subject of patent rights. The issuing authority shall not be held

responsible for identifying any or all such patent rights.

This Standard shall be under the jurisdiction of Institute of Electronic Industry

Standards, Ministry of Industry and Information Technology.

Main drafting organizations of this Standard. BYD Auto Industry Co., Ltd., Chery

New Energy Automotive Technology Co., Ltd., Jianghuai Automobile Co., Ltd.,

Shanghai Electric Drive Co., Ltd., Shenzhen Huichuan Technology Co., Ltd.,

Shenzhen Lanhai Huateng Technology Co., Ltd., Shanghai Zhongke Shenjiang

Electric Vehicle Co., Ltd., Huizhou BYD Battery Co., Ltd., Xiamen Farah

Electronics Co., Ltd., Wuxi Zhonghui Automotive Electronic Technology Co.,

Ltd., Car Information Service Industry Application Alliance.

Main drafters of this Standard. Yang Wei, Yang Guangming, Wu Rui, Rao

Shengyuan, Wu Hongliang, Xu Hua, Chen Xuanwei, Xu Yandong, Xu Xuehai,

Zeng Dezhi, Luo Jian, Sun Jiangming, Yang Ruicheng, Chen Haitao.

Supporting high-voltage bus capacitors selective

specifications for electric vehicle motor controller

1 Scope

This Specifications specifies the selective requirements for supporting high-

voltage bus capacitors for electric vehicle motor controller (hereinafter referred

to as the capacitor), mainly including the selective requirements for DC-Link

capacitors. Other types of capacitors can refer to use.

This Specifications is applicable to the capacitors for hybrid vehicle with rated

DC voltage over 60V, plug-in hybrid vehicle and pure electric vehicle.

2 Normative references

The following referenced documents are indispensable for the application of

this document. For dated references, only the edition cited applies. For undated

references, the latest edition of the referenced document (including any

amendments) applies.

GB/T 2423.1-2008, Environmental testing - Part 2. Test methods - Tests A.

Cold

GB/T 2423.2-2008, Environmental testing - Part 2. Test methods - Tests B.

Dry heat

GB/T 2423.3-2006, Environmental testing for electric and electronic products

- Part 2. Testing method test Cab. Damp heat Steady state

GB/T 2423.22-2012, Environmental testing - Part 2. Tests methods - Test N.

Change of temperature

GB/T 2693-2001, Fixed capacitors for use in electronic equipment - Part 1.

Generic specification

GB/T 17702-2013, Capacitors for power electronics (IEC 61071.2007, IDT )

GB/T 19596, Terminology of electric vehicles

GB/T 28046.3-2011, Road vehicles - Environmental conditions and testing

for electrical and electronic equipment - Part 3. Mechanical loads

requirements.