Valid

GB/T 8570.3-2010Determination of liquefied anhydrous ammonia - Part 3: Residue content - Gravimetric method (English PDF)

液体无水氨的测定方法 第3部分:残留物含量 重量法

Preview PDF

This is a limited preview

Buy now to download the full PDF (15 pages)

Need quotation for your management?

Get a formal quotation for GB/T 8570.3-2010 in 30 minutes.

Issued by

SAMR; SAC

Level / Type

National · Recommended

Issue date

September 26, 2010

Implementation date

March 1, 2011

Scope

GB/T 8570.3-2010 is the English-translated version of 液体无水氨的测定方法 第3部分:残留物含量 重量法.

GB/T 8570.3-2010 is the gravimetric method for the residue content of liquefied anhydrous ammonia and is Part 3 of GB/T 8570. The sample is evaporated at room temperature, the residue is weighed, the ammonia still in it is titrated with 0.1 mol/L sulfuric acid against a 1 g/L methyl red indicator, and that ammonia is subtracted to leave the residue.

It lists a dry-ice and industrial-alcohol refrigerant at -35 °C to -40 °C and a sampling apparatus built from a graduated 150 mL glass tube, three-way pistons and two conical flasks.

It applies to products whose residue content is not less than 0.02% and is the arbitration method for residue; below that limit the result is reported as a mass fraction < 0.02%.

Issued on 26 September 2010, it replaces GB/T 8570.3-1988 and has applied since 1 March 2011.

Found what you need?

Document preview — GB/T 8570.3-2010

National Standard of the People's Republic of China

ICS
71.040.40
Classification
G 10
Replacing
GB 8570.3-1988

Issued by: State Administration for Market Regulation; Standardization Administration of the PRC

Contents

  • Foreword
  • 1 Scope
  • 2 Normative reference documents
  • 3 Principle
  • 4 Reagents and materials
  • 5 Instruments

Foreword

GB/T 8570 "Determination of liquid anhydrous ammonia method" is divided into seven parts.

- Part 1. Adoption of laboratory samples;

- Part 2. Ammonia content;

- Part 3. Residue content weight method;

- Part 4. Residual content volumetric method;

- Part 5. Moisture Fisher Fischer;

- Part 6. Oil content gravimetric and infrared absorption spectroscopy;

- Part 7. Iron content - phenanthroline spectrophotometric method.

This part is part 3 of GB/T 8570.

This part of the replacement of GB/T 8570.3-1988 "liquid anhydrous ammonia residue content determination of weight method." The main differences between this edition and the previous edition are.

Preparation and calibration of reagent solutions, standard titration solutions, etc. Execution of HG/T 2843 standards;

--- increase the contents of the security warning;

- standardize the standard format according to the new requirements.

1 Scope

This standard specifies the determination of liquid anhydrous ammonia (liquid ammonia) residue by gravimetric method.

This standard applies to products with a residue content of not less than 0.02%, and an arbitration method for determining the content of residues.

Note: If the residue content is lower than the lower limit of the standard measurement method, the report is the mass fraction < 0.02%.

2 Normative reference documents

The terms of this document are the terms of this part by reference to this part of GB/T 8570. Any reference to the date of the text, All subsequent amendments (excluding corrigenda) or revisions do not apply to this part, however, encouragement under this section The parties to the agreement study whether the latest version of these documents can be used. For undated references, the latest edition of this document applies section.

GB/T 8570.1-2008 Methods for the determination of liquid anhydrous ammonia - Part 1: Adoption of laboratory samples

HG/T 2843 chemical analysis of chemical fertilizers commonly used standard titration solution, standard solution, reagent solution and indicator solution

3 Principle

After evaporation of the liquid ammonia sample at room temperature, the evaporation residue was weighed and the residue was titrated in a standard solution of sulfuric acid in the presence of an indicator Of the ammonia, the amount of residue obtained by subtracting the measured ammonia content from the residue of the residue, and obtaining the residue content.

4 Reagents and materials

The reagents, solutions and water used in this part shall comply with the requirements of HG/T 2843 when not specified and formulated.

4.1 sulfuric acid solution. about 10%.

4.3 methyl red indicator solution. 1g/L.

4.4 Refrigerants. solid carbon dioxide (dry ice) and industrial alcohol mixture, the cooling temperature -35 °C ~ -40 °C;

4.5 Grease, lubricating glass piston.

4.2 Sulfuric acid standard titration solution, c (12H2SO4

) = 0.1 mol/L;

5 Instruments

5.1 General laboratory equipment.

5.2 Sample sampling device, see Figure 1

5.2.1 glass tube. the total volume of about 150mL, 100mL engraved with marking, No. 29 internal standard grinding with the corresponding external standard grinding mouth Glass plug, so that one of the pipe connected to the three-way piston 3, the other branch with two 1000mL conical bottles I and II in series.

Thus, in the assembled instrument, the test tube can be connected with two three-way pistons 3 and 4, respectively, and liquid ammonia sampling cylinders and two conical bottles I, II connection.

The glass piston is lubricated with silicone grease or made of polytetrafluoroethylene.

......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 15 pages — is available in the English PDF.

Referenced standards

Similar standards

Editions of GB/T 8570.3

EditionTitleRevisionStatus
GB/T 8570.3-2010Determination of liquefied anhydrous ammonia - Part 3: Residue content - Gravimetric methodcurrent editionCurrent
GB 8570.3-1988Determination of liquefied anhydrous ammonia - Part 3: Residue content - Gravimetric methodprevious editionSuperseded

This page sells the current edition, GB/T 8570.3-2010. Earlier editions are listed for reference only.

How to Download GB/T 8570.3-2010

  1. 1

    Add to cart

    Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.

  2. 2

    Checkout

    Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).

  3. 3

    Instant delivery (0–9 sec)

    Delivery is automatic: within seconds of payment you'll receive an email with a secure download link. The link stays valid for 72 hours.

  4. 4

    Invoice included

    A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.

Related Standards

English PDF
15 pages
Instant delivery (0–9 sec)
Invoice included
View Cart

Secure payment via Stripe

Payments accepted

VisaMastercardAmerican ExpressApple PayGoogle PayStripe

GB/T 8570.3-2010

$85.00