GB/T 4169.2-2006Components of injection moulds for plastics - Part 2: Straight guide bush (English PDF)

1 Scope

This standard specifies the plastic injection mold with a straight guide sleeve dimensions and tolerances.

This section applies to straight bushings used in plastic injection molding.

This section also gives guidelines and material hardness.

Well guide provides straight sets mark.

Foreword

This document was issued on 8 December 2006 by the State Administration for Market Regulation and the Standardization Administration of the People's Republic of China, and has been in force since 1 April 2007.

It replaces GB/T 4169.2-1984.

Classification: ICS 25.120.30, CCS J46.

About this edition

GB/T 4169.2-2006 is the current edition. It was issued on 8 December 2006 and has been in force since 1 April 2007, replacing GB/T 4169.2-1984.

GB/T 4169.2-1984 has been superseded: a specification that still cites it is citing a withdrawn edition.

The interval between issue and effect is the transition period. It exists so that producers, laboratories and buyers can requalify products, revise procedures and use up documentation before the new text becomes the one that applies. The date on this page is the official one from the record of the Standardization Administration.

Edition history and citation

GB/T 4169.2-2006 replaces GB/T 4169.2-1984. A specification, drawing or test report that cites the older number is pointing at a document that is no longer the one in force, and the two editions can differ in requirements, in test methods or in scope.

Where an edition is replaced, the Chinese standardization system keeps the number and changes the year: the number identifies the subject, the year identifies the text. That is why a citation without a year is ambiguous and a citation with one is not.

Classification and status

GB/T 4169.2-2006 is classified under ICS 25.120.30, in the field of manufacturing engineering. ICS is the International Classification for Standards, the same scheme used by ISO and by the national bodies of most countries, which is what allows a Chinese standard to be placed beside its foreign counterparts on subject rather than on number.

Its Chinese Standard Classification code is CCS J46. CCS is the domestic scheme, a letter for the sector and two digits for the subject within it, and it is the code by which the standard is filed and searched in China.

The GB/T prefix marks a recommended national standard. It is not, in itself, law: it becomes binding when a contract names it, when a regulation or a mandatory standard refers to it, or when a producer declares conformity with it. In practice that covers most of the cases in which it will be read — a purchase specification, an inspection agreement or a certification scheme.

How this standard is designated

The full designation is GB/T 4169.2-2006. A citation should carry the number with its year, because the year identifies the text that applies.

In a catalogue or a filing system it is found under ICS 25.120.30 and CCS J46 — the international classification and the Chinese one, which are the two codes by which a standard on this subject is searched.