Valid

GB/T 35656-2017Guideline for verification and validation of chemical analysis method and internal quality control—Method on reporting qualitative test reports (English PDF)

化学分析方法验证确认和内部质量控制实施指南 报告定性结果的方法

Preview PDF

This is a limited preview

Buy now to download the full PDF (20 pages)

Need quotation for your management?

Get a formal quotation for GB/T 35656-2017 in 30 minutes.

Issued by

SAMR; SAC

Level / Type

National · Recommended

Issue date

December 29, 2017

Implementation date

July 1, 2018

Scope

GB/T 35656-2017 is the English-translated version of 化学分析方法验证确认和内部质量控制实施指南 报告定性结果的方法.

GB/T 35656-2017 is the Chinese standard "Guideline for verification and validation of chemical analysis method and internal quality control—Method on reporting qualitative test reports".

Its scope clause reads: This standard gives the chemical analysis of qualitative results reported in the verification method validation and laboratory internal quality control requirements and implementation guidelines.

This standard applies to the chemical analysis of qualitative results reported in the validation test and laboratory internal quality control. This standard does not apply to sampling. Its clauses include terms and definitions.

Found what you need?

Document preview — GB/T 35656-2017

National Standard of the People's Republic of China

ICS
03.120.10
Classification
A 00

Issued by: State Administration for Market Regulation; Standardization Administration of the PRC

Contents

  • Preface
  • Introduction
  • 1 Scope
  • 2 Normative references
  • 3 Terms and definitions
  • 4 General
  • 4.1 Chemical Analysis Method Classification
  • 4.2 Report qualitative characteristics of the method
  • 4.3 Report Qualitative Results Method Verification Confirmation Requirements
  • 4.4 limit test
  • 4.5 Qualitative and broad-spectrum screening methods
  • 4.6 preparation of standard operating procedures
  • 5 pairs of method performance verification and validation requirements
  • 5.1 Sensitivity
  • 5.2 Selectivity and specificity
  • 5.3 Threshold
  • 5.4 false negative rate and false positive rate
  • 5.5 Detection limit
  • 6 Internal Quality Control
  • Appendix A (informative) method of threshold calculation example
  • Appendix B (Informative) Sensitivity-specific performance indicators confirm Example
  • Appendix C (informative) Examples of interference tests and interference cancellation
  • Appendix D (informative) method threshold determination example
  • Appendix E (informative) t test threshold Table
  • References

1 Scope

This standard gives the chemical analysis of qualitative results reported in the verification method validation and laboratory internal quality control requirements and implementation guidelines.

This standard applies to the chemical analysis of qualitative results reported in the validation test and laboratory internal quality control.

This standard does not apply to sampling.

2 Normative references

The following documents for the application of this document is essential. For dated references, only the dated version applies to this article

Pieces. For undated references, the latest edition (including all amendments) applies to this document.

GB/T 6379.1 accuracy and accuracy of measurement methods (accuracy and precision) Part 1. General and definitions

GB/T 14666 analytical chemistry terminology

GB/T 19000 quality management system foundation and terminology

GB/T 27025-2008 General requirements for the competence of testing and calibration laboratories

Chemical analysis methods validation verification and internal quality control requirements GB/T 32465-2015

GB/T 32467 chemical analysis methods validation validation and internal quality control terms and definitions

GB/T 33464 chemical analysis standard operating procedures and guidelines for the preparation and use

ISO 11843-1 detection capabilities Part 1. Terms and definitions (Capabilityofdetection-Part 1.Termsanddefi- nitions

3 Terms and definitions

GB/T 6379.1, GB/T 14666, GB/T 19000, GB/T 32467 and ISO 11843-1 as defined by the following terms and definitions

Meaning applies to this document.

3.1 Positive predictive value positivepredictivevalues; PPV

The ratio of true positives to total positives was determined.

Note. The total positive results include the sum of the true positives and the false positives. Positive predictive value = true positive result/(true positive result false positive result).

3.2 Negativepredictivevalues; NPV

The ratio of true negative results to total negative results was determined.

Note. The total negative results include the sum of true negative and false negative results. Negative predictive value = true negative result/(true negative result false negative result).

3.3 Qualitative broad-spectrum screening qualitativebroad-band (non-targeted)

Using a specific method, multiple target components are detected at the same time, and the result is compared with the reference data to obtain a "yes" or "no" target group

Points of conclusion.

......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 20 pages — is available in the English PDF.

Similar standards

How to Download GB/T 35656-2017

  1. 1

    Add to cart

    Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.

  2. 2

    Checkout

    Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).

  3. 3

    Fast delivery

    After payment you'll receive an email confirmation. The English PDF is sent to the same address, usually within minutes and at the latest within 1 business day.

  4. 4

    Invoice included

    A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.

Related Standards

English PDF
20 pages
Fast delivery
Invoice included
View Cart

Secure payment via Stripe

Payments accepted

VisaMastercardAmerican ExpressApple PayGoogle PayStripe

GB/T 35656-2017

$355.00