Valid

GB/T 33843-2017Test method for access network equipment—Passive optical network based on ethernet (EPON) (English PDF)

接入网设备测试方法基于以太网方式的无源光网络（EPON）

Preview PDF

This is a limited preview

Buy now to download the full PDF (49 pages)

Need quotation for your management?

Get a formal quotation for GB/T 33843-2017 in 30 minutes.

Issued by

SAMR; SAC

Level / Type

National · Recommended

Issue date

May 31, 2017

Implementation date

December 1, 2017

Scope

GB/T 33843-2017 is the English-translated version of 接入网设备测试方法基于以太网方式的无源光网络（EPON）.

GB/T 33843-2017 is the Chinese standard "Test method for access network equipment—Passive optical network based on ethernet (EPON)".

Its scope clause reads: This standard specifies the system configuration of a passive optical network (EPON) device with a transmission rate of gigabit, Ethernet-based, Test reference point and the device's OLT/ONU line transmission optical interface, network side interface and user side interface, transmission performance, function, network management, Equipment safety and other test methods.

This standard applies to the public telecommunications network environment EPON equipment, special telecommunications network can also refer to the use. Its clauses include normative reference documents.

Found what you need?

Document preview — GB/T 33843-2017

National Standard of the People's Republic of China

ICS: 33.040.50
Classification: M 33

Issued by: State Administration for Market Regulation; Standardization Administration of the PRC

Preface
1 Scope
2 normative reference document
3 terms, definitions and abbreviations
4 system reference configuration and test reference point
4.1 EPON System Reference Configuration
4.2 EPON test reference point
5 OLT, ONU line transmission optical interface characteristics of the test
5.1 Average transmit power
5.2 Laser operating wavelength
5.3 Maximum RMS spectral width of MLM lasers
5.4 SLM laser maximum -20dB spectral width
5.5 SLM laser minimum side mode rejection ratio of
5.6 Transmitter Eye Figure
5.7 extinction ratio
5.8 Emission light modulation amplitude
5.9 Receiver sensitivity test
5.10 Receiver overload power
5.11 Receiver reflection coefficient
6 network side and user side interface test
6.1 Network side and user side interface requirements
6.2 GE interface
6.3 FE interface
6.4 10GB ASE-X interface
6.5 E1 interface
6.6 Z interface
6.7 Za interface
6.8 ADSL2 interface
6.9 VDSL2 interface
7 transmission performance test
7.1 Maximum shunt ratio and transmission distance
7.2 Distance function verification
7.3 N × 64kbit/s digital connection and 2048kbit/s channel performance test
7.4 IP Performance Test
8 Functional Verification
8.1 Dynamic Bandwidth Allocation (DBA) Function
8.2 Business QoS Assurance
8.3 encryption function
8.4 ONU authentication function
8.5 VLAN function
8.6 frame filtering function
8.7 Broadcast/multicast frame suppression function
8.8 Layer 2 isolation function
8.10 Multicast function
8.11 SCB test
8.12 Link Aggregation Function
8.13 VLANstacking
8.14 ONU power-down notification function
8.15 Optical fiber protection switching function
8.16 VoIP Test
9 Operation and Maintenance Management Function Verification
9.1 Management Verification
9.2 Configuration Management
9.3 Performance Management
9.4 Fault and alarm management
9.5 Safety Management
10.1 Test Sequence
10.2 Low temperature test
10.3 High temperature test
10.4 High humidity test
10.5 Optical fiber temperature change test
11 Power Test

1 Scope

This standard specifies the system configuration of a passive optical network (EPON) device with a transmission rate of gigabit, Ethernet-based,

Test reference point and the device's OLT/ONU line transmission optical interface, network side interface and user side interface, transmission performance, function, network management,

Equipment safety and other test methods.

This standard applies to the public telecommunications network environment EPON equipment, special telecommunications network can also refer to the use.

2 normative reference documents

The following documents are indispensable for the application of this document. For dated references, only the dated edition applies to this article

Pieces. For undated references, the latest edition (including all modifications) applies to this document.

GB/T 7611-2001 Digital network series Bit rate Electrical interface characteristics

Information technology equipment - Radio disturbance limits and methods of measurement GB 9254-2008

Test method for transmission performance of optical fiber communication systems GB/T 14760-1993

Information technology equipment - Immunity limits and measurement methods GB/T 17618-1998

GB/T 29229-2012 Passive Optical Network (EPON) Technical Requirements Based on Ethernet

Method for detecting the incoming network of digital telephone exchange equipment in public telephone network

YD/T 1034-2013 access network noun terms

Router equipment - Test methods - Edge router

YD/T 1141-2007 Ethernet switch test method

Routing device - Test method - Core router

YD/T 1240-2002 Access network equipment test method - Broadband access network equipment based on Ethernet technology

YD/T 1250-2003 Access Network Test Method - Passive Optical Network Based on ATM (A-PON)

Test Method of Integrated Access Equipment Based on Softswitch YD/T 1532-2006

YD/T 2278-2011 access network equipment test method The second generation of very high-speed digital subscriber line (VDSL2)

IEEE802.1ag-2007 LAN and MAN Virtual Bridge LAN Modification 5. Connectivity Fault Management (Loclaand metropolitanareanetworks-Virtualbridgedlocalareanetworks-Amendment5. Connectivityfault management

IEEE802.1D-2004 LAN and Metropolitan Area Network Media Access Control (MAC) Bridge [Localandmetropolitanarea networks-Mediaaccesscontrol (MAC) bridges]

IEEE802.1Q-2005 LAN and metropolitan area network virtual bridged LAN (Localand metropolitanarea networks-Virtualbridgedlocalareanetworks)

IEEE802.1X-2004 LAN and MAN based port access control (Localandmetropolitanarea networks-Portbasednetworkaccesscontrol

IEEE802.3-2008 Communication and information exchange between information technology systems LAN and metropolitan area networks Special requirements Part 3

Points. CSMA/CD access method and physical layer specification [Localandmetropolitanareanetworks-Specificrequirements-

Part 3. Carriersensemultipleaccesswithcolisiondetection (CSMA/CD) accessmethodandphysical […]

......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 49 pages — is available in the English PDF.

Referenced standards

Normative references

GB 9254-2008 · GB/T 17618-1998 · YD/T 751-1995 · YD/T 1034-2013 · YD/T 1098-2009 · YD/T 1156-2009 · YD/T 1240-2002 · YD/T 1250-2003 · IEEE 802.1ag-2007 · IEEE 802.1D-2004 · IEEE 802.1Q-2005 · IEEE 802.1X-2004 · IEEE 802.3-2008

Similar standards

GB/T 46463-2025|GB/T 46882-2025|GB/T 44816.2-2024|GB/T 40420.3-2021|GB/T 40420.4-2021|GB/T 40420.7-2021

How to Download GB/T 33843-2017

1
Add to cart
Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.
2
Checkout
Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).
3
Instant delivery (0–9 sec)
Delivery is automatic: within seconds of payment you'll receive an email with a secure download link. The link stays valid for 72 hours.
4
Invoice included
A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.