Valid

GB/T 31388-2015Heat cost allocators with electrical energy supply (English PDF)

电子式热量分配表

Preview PDF

This is a limited preview

Buy now to download the full PDF (15 pages)

Need quotation for your management?

Get a formal quotation for GB/T 31388-2015 in 30 minutes.

Issued by

SAMR; SAC

Level / Type

National · Recommended

Issue date

February 4, 2015

Implementation date

November 1, 2015

Scope

GB/T 31388-2015 is the English-translated version of 电子式热量分配表.

GB/T 31388-2015 is the Chinese standard "Heat cost allocators with electrical energy supply". Its scope clause reads: This standard specifies the terms and definitions electronic heat distribution table, the general requirements, requirements, test methods, inspection rules, marking, packaging, Transportation and storage.

This standard applies to building indoor hot water heating system for measuring the ratio of the heat sink for heat dissipation and apportionment of electronic thermal Volume allocation table (hereinafter referred to as "heat distribution table"), does not apply to forced convection radiator, steam radiators and wall (floor and roof, etc.) radiation Heating system. Its clauses include terms and definitions.

Found what you need?

Document preview — GB/T 31388-2015

National Standard of the People's Republic of China

ICS
91.140.60
Classification
P 40

Issued by: State Administration for Market Regulation; Standardization Administration of the PRC

Contents

  • 1 Scope
  • 2 Normative references
  • 3 Terms and Definitions
  • 3.1 Electronic heat distribution table
  • 3.2 He had a temperature
  • 3.3 Reference point air temperature
  • 3.4 Heat settlement point

1 Scope

This standard specifies the terms and definitions electronic heat distribution table, the general requirements, requirements, test methods, inspection rules, marking, packaging,

Transportation and storage.

This standard applies to building indoor hot water heating system for measuring the ratio of the heat sink for heat dissipation and apportionment of electronic thermal

Volume allocation table (hereinafter referred to as "heat distribution table"), does not apply to forced convection radiator, steam radiators and wall (floor and roof, etc.) radiation

Heating system.

2 Normative references

The following documents for the application of this document is essential. For dated references, only the dated version suitable for use herein

Member. For undated references, the latest edition (including any amendments) applies to this document.

GB 4208 housing protection (IP Code)

GB/T 13754 Determination of the amount of heating radiator heat

GB/T 17626.2-2006 Electromagnetic compatibility - Testing and measurement techniques - Electrostatic discharge immunity test

JGJ173 heat metering Technical Specification

3 Terms and Definitions

GB/T 13754 and JGJ173 defined and the following terms and definitions apply to this document. For ease of use, the following listed repeatedly

The GB/T 13754 and JGJ173 some terms and definitions.

3.1 Electronic heat distribution table

By the housing, the heat conductive plate, a temperature sensor, a microprocessor, display, power supply, and the fixed seal member and other components, the heat sink is fixed to the work

The surface of a specific location, it had to calculate the temperature of the heating time integral value of the instrument can be calculated by each radiating remote data processing system

All internal heat radiator clearing point ratio is the total amount of heat radiating accounts, and then based on the ratio and calorific value of the settlement point in the heat derived from the count

Count allocated to each radiator of heat dissipation.

3.2 He had a temperature

Radiator out of the water and the average temperature difference between the air temperature reference point.

NOTE. rewrite GB/T 13754-2008, definitions 3.8.

3.3 Reference point air temperature

Test Chambers, radiating from the square in front of the radiator 1.5m, 0.75m measured at a distance to the air temperature.

NOTE. rewrite GB/T 13754-2008, definitions 3.7.

3.4 Heat settlement point

Between the heating side and the hot side for trade settlement location directly by the calorific value of the calorimeter measurement.

......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 15 pages — is available in the English PDF.

Similar standards

How to Download GB/T 31388-2015

  1. 1

    Add to cart

    Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.

  2. 2

    Checkout

    Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).

  3. 3

    Fast delivery

    After payment you'll receive an email confirmation. The English PDF is sent to the same address, usually within minutes and at the latest within 1 business day.

  4. 4

    Invoice included

    A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.

Related Standards

English PDF
15 pages
Fast delivery
Invoice included
View Cart

Secure payment via Stripe

Payments accepted

VisaMastercardAmerican ExpressApple PayGoogle PayStripe

GB/T 31388-2015

$95.00