Valid

GB/T 27985-2011Determination of tannin in feeds - Spectrophotometry (English PDF)

饲料中单宁的测定 分光光度法

Preview PDF

This is a limited preview

Buy now to download the full PDF (15 pages)

Need quotation for your management?

Get a formal quotation for GB/T 27985-2011 in 30 minutes.

Issued by

SAMR; SAC

Level / Type

National · Recommended

Issue date

December 30, 2011

Implementation date

June 1, 2012

Scope

GB/T 27985-2011 is the English-translated version of 饲料中单宁的测定 分光光度法.

GB/T 27985-2011 is the Chinese standard "Determination of tannin in feeds -- Spectrophotometry". Its scope clause reads: This Standard specifies the spectrophotometry for the determination of tannin in feeds.

This Standard applies to the determination of tannin content in compound feeds and single feeds.

The detection-limit of this method is 17.5 mg/kg, and the linear range is 0.50 mg/L ~ 6.00 mg/L. Its clauses include principle; reagents and solutions; instruments and equipment; sample preparation; analysis steps; calculation and expression of results; repeatability.

It was issued by the General Administration of Quality Supervision, Inspection and Quarantine on DECEMBER 30, 2011 and took effect on JUNE 01, 2012.

Found what you need?

Document preview — GB/T 27985-2011

National Standard of the People's Republic of China

ICS
65.120
Classification
B 46

Issued by: State Administration for Market Regulation; Standardization Administration of the PRC

Contents

  • Foreword3
  • 1 Scope4
  • 2 Normative references4
  • 3 Principle4
  • 4 Reagents and solutions4
  • 5 Instruments and equipment5
  • 6 Sample preparation6
  • 7 Analysis steps6
  • 8 Calculation and expression of results7
  • 9 Repeatability7

1 Scope

This Standard specifies the spectrophotometry for the determination of tannin in feeds.

This Standard applies to the determination of tannin content in compound feeds and single feeds.

The detection-limit of this method is 17.5 mg/kg, and the linear range is 0.50 mg/L ~ 6.00 mg/L.

2 Normative references

The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies to this document. For undated references, the latest edition (including any amendment) applies to this document.

GB/T 6682, Water for analytical laboratory use - Specification and test methods

GB/T 14699.1, Feeding stuffs - Sampling

GB/T 20195, Animal feeding stuffs - Preparation of test samples

3 Principle

Use acetone solution to extract tannin compounds in the feed; after filtration, take the filtrate, add sodium tungstate-phosphomolybdic acid mixed solution and sodium carbonate solution; after color development, use the reagent as a blank control; use a spectrometer to determine the absorbance value at a wavelength of 760 nm; use tannic acid as a standard curve to determine the tannin content in the feed.

4 Reagents and solutions

Unless otherwise specified, the reagents used in this Standard shall be analytical reagents, and the water shall comply with the provisions of GB/T 6682 for grade-3 water.

4.1 Sodium tungstate (Na2O4W·2H2O).

4.2 Phosphomolybdic acid (H3Mo12O40P·XH2O).

5 Instruments and equipment

5.8 Erlenmeyer flask with stopper: 250 mL.

5.9 Medium-speed quantitative filter paper.

6 Sample preparation

Take samples according to GB/T 14699.1; prepare samples according to GB/T 20195.

Grind them; pass them through a 0.45 mm sieve; mix well; put them in airtight containers; store them at low temperature in the dark for future use.

7 Analysis steps

7.1 Preparation of test solution

Weigh 1 g ~ 2 g of the sample (accurate to 0.000 1 g); put it into a 250 mL Erlenmeyer flask with stopper (5.8); add 50.00 mL of acetone solution (4.7) accurately; seal it with a stopper; place it on an oscillator (5.4) and shake for 40 min; let it stand still; use medium-speed quantitative filter paper (5.9) to filter; discard the initial filtrate, and continue the filtration for determination.

7.2 Determination

7.2.1 Drawing of the standard curve

Accurately measure 0.00 mL, 0.50 mL, 1.00 mL, 2.00 mL, 3.00 mL, 4.00 mL, 5.00 mL and 6.00 mL of tannic acid standard solution (4.10); respectively put them into 50 mL volumetric flasks filled with about 30 mL of water; shake well; add 2.5 mL of sodium tungstate-phosphomolybdic acid mixed solution (4.3); add 5.0 mL of sodium carbonate solution (4.5); shake well; use water to dilute to 50 mL respectively; shake well. The concentration of tannic acid standard solution is 0.00 mg/L, 0.50 mg/L, 1.00 mg/L, 2.00 mg/L, 3.00 mg/L, 4.00 mg/L, 5.00 mg/L and 6.00 mg/L respectively. Let it stand for 30 min; after color development, use 0.00 mg/L of the standard curve as the blank; measure the absorbance of the standard solution at a wavelength of 760 nm; draw the standard curve with the concentration of tannin as the abscissa and the absorbance value as the ordinate.

7.2.2 Determination of sample

Accurately measure 1.00 mL of the test solution (7.1); put it into a 50 mL volumetric flask filled with about 30 mL of water; shake well; add 2.5 mL of sodium tungstate-phosphomolybdic acid mixed solution (4.3); add 5.0 mL of sodium carbonate solution (4.5); shake well; use water to dilute to 50 mL; shake well. Let it stand for 30 min to develop color; then, use 0.00 mg/L of the standard curve as a blank; measure the absorbance of the sample solution at a wavelength of 760 nm; obtain the concentration of tannin in the test solution (7.1) according to the standard curve. If the absorbance […]

......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 15 pages — is available in the English PDF.

Referenced standards

Similar standards

How to Download GB/T 27985-2011

  1. 1

    Add to cart

    Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.

  2. 2

    Checkout

    Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).

  3. 3

    Fast delivery

    After payment you'll receive an email confirmation. The English PDF is sent to the same address, usually within minutes and at the latest within 1 business day.

  4. 4

    Invoice included

    A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.

Related Standards

English PDF
15 pages
Fast delivery
Invoice included
View Cart

Secure payment via Stripe

Payments accepted

VisaMastercardAmerican ExpressApple PayGoogle PayStripe

GB/T 27985-2011

$85.00