GB/T 26466-2011Stationary flat steel ribbon wound vessels for storage of high pressure hydrogen (English PDF)

1 Scope

This standard specifies the stationary high-pressure hydrogen storage container with a strip wrong about the design, manufacture, inspection and acceptance requirements.

This standard applies to both of the following conditions are stationary high-pressure hydrogen storage container with a strip wound wrong.

a) greater than the design pressure of less than or equal to 10MPa and 100MPa;

b) greater than or equal to the design temperature -40 °C deg.] C and less than or equal to 80;

c) 300mm inner diameter greater than or equal to and less than or equal to 1500mm, the design pressure (MPa) and the inner diameter (mm) of the product of

Not more than 75,000.

2 Normative references

The following documents contain provisions which, through reference in this standard and become the standard terms. For dated references, subsequent

Amendments (not including errata content) or revisions do not apply to this standard, however, encourage the parties to the agreement are based on research

Whether the latest versions of these documents. For undated reference documents, the latest versions apply to this standard.

GB/T 228-2002 metallic materials at room temperature tensile test method

GB/T 229-2007 metallic materials - Charpy pendulum impact test method

GB 713-2008 boiler and pressure vessel steel plate

GB 3531-2008 cryogenic low-alloy steel plates for pressure vessels

GB 6653-2008 with steel sheet and strip for welded gas cylinders

JB4708-2000 steel pressure vessel welding procedure qualification

JB/T 4711-2003 applying pressure vessels and transport packaging

JB4726-2000 pressure vessel carbon steel and low alloy steel forgings

JB4727-2000 temperature pressure vessels low alloy steel forgings

JB4728-2000 pressure vessel steel forgings

JB/T 4730.2-2005 pressure equipment Non-destructive testing - Part 2. ray detector

JB/T 4730.3-2005 Nondestructive testing of pressure equipments - Part 3. Ultrasonic testing

JB/T 4730.5-2005 Nondestructive Testing Pressure Equipment - Part 5. penetrant testing

JB4732-1995 steel pressure vessel - Analysis and Design Standard (2005 edition confirmed)

JB4733-1996 stainless steel pressure vessel explosion composite plate

3 Definitions, symbols