GB/T 23943-2009Inorganic chemicals for industrial use - General method for the determination of chromium(VI) content - 1,5-diphenylcarbohydrazide spectrophotometric method (English PDF)
无机化工产品中六价铬含量测定的通用方法 二苯碳酰二肼分光光度法
This is a limited preview
Buy now to download the full PDF (15 pages)
Need quotation for your management?
Get a formal quotation for GB/T 23943-2009 in 30 minutes.
Issued by
SAMR; SAC
Level / Type
National · Recommended
Issue date
June 2, 2009
Implementation date
February 1, 2010
Scope
GB/T 23943-2009 is the English-translated version of 无机化工产品中六价铬含量测定的通用方法 二苯碳酰二肼分光光度法.
GB/T 23943-2009 is the Chinese standard "Inorganic chemicals for industrial use - General method for the determination of chromium(VI) content - 1,5-diphenylcarbohydrazide spectrophotometric method".
Its scope clause reads: This standard specifies the general method of inorganic chemical products Determination of hexavalent chromium --- diphenyl hydrazine spectrophotometry principle, Safety tips, general provisions, reagents, instruments, equipment, analytical procedures and the results of calculations.
This standard applies to inorganic chemical products - Determination of trace hexavalent chromium ions, hexavalent chromium (Cr6 +) at 0.004mg/L ~ 1.000mg/L range is linear.
The test solution volume 50mL, using the optical path length of the cuvette than 3cm, the method of the smallest Detection limit was 0.2µg hexavalent chromium, the detection limit was 0.004mg/L; using the optical path than 1cm cuvette, measuring the concentration limit 1.000mg/L (does not interfere with the determination of ions see Appendix A). Its clauses include safety tips; general provisions; reagents.
Found what you need?
Document preview — GB/T 23943-2009
National Standard of the People's Republic of China
- ICS
- 71.060.01
- Classification
- G 10
Issued by: State Administration for Market Regulation; Standardization Administration of the PRC
Contents
- 1 Scope
- 2 Normative references
- 4 Safety Tips
- 5 General Provisions
- 6 Reagents
1 Scope
This standard specifies the general method of inorganic chemical products Determination of hexavalent chromium --- diphenyl hydrazine spectrophotometry principle,
Safety tips, general provisions, reagents, instruments, equipment, analytical procedures and the results of calculations.
This standard applies to inorganic chemical products - Determination of trace hexavalent chromium ions, hexavalent chromium (Cr6 +) at 0.004mg/L ~
1.000mg/L range is linear. The test solution volume 50mL, using the optical path length of the cuvette than 3cm, the method of the smallest
Detection limit was 0.2µg hexavalent chromium, the detection limit was 0.004mg/L; using the optical path than 1cm cuvette, measuring the concentration limit
1.000mg/L (does not interfere with the determination of ions see Appendix A).
2 Normative references
The following documents contain provisions which, through reference in this standard and become the standard terms. For dated references, subsequent
Amendments (not including errata content) or revisions do not apply to this standard, however, encourage the parties to the agreement are based on research
Whether the latest versions of these documents. For undated reference documents, the latest versions apply to this standard.
GB/T 6682-2008 analytical laboratory use specifications and test methods (ISO 3696. 1987, MOD)
Preparation of HG/T 3696.2 inorganic chemical products, chemical analysis of impurity standard solution
Preparations of HG/T 3696.3 inorganic chemical products, chemical analysis
Principle 3
In acidic solution, hexavalent chromium diphenyl hydrazine reacts with purple compound, at a wavelength of 540nm at a concentration of the complex
Absorbance line with Lambert - Beer law, can be used for the determination. The molar extinction coefficient of 4 × 104.
4 Safety Tips
Reagents used in this test method are toxic or corrosive, the operator must be careful! Such as water splashed on the skin should immediately
Flushing, severe cases should be treated immediately.
5 General Provisions
This standard reagents and water, did not indicate when the other requirements, refer to analytically pure reagents and GB/T 6682-2008 specified three
Grade water.
Impurity standard solution, preparations and products needed to test, in the absence of other requirements specified according to HG/T 3696.2, HG/T 3696.3
Provisions prepared.
6 Reagents
Sulfuric acid solution was 6.1. 1 + 1.
Phosphoric acid 6.2. 1 + 1.
6.3 Sodium hydroxide solution
4g/L.
6.4 chromium standard stock solution
1mL solution containing chromium (Cr) 0.10mg.
GB/T 23948-2023 | GB/T 23940-2021 | GB/T 23834.1-2009 | GB/T 23941-2025 | GB/T 23950-2024 | GB/T 23944-2023 | […]
......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 15 pages — is available in the English PDF.
Referenced standards
Similar standards
How to Download GB/T 23943-2009
- 1
Add to cart
Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.
- 2
Checkout
Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).
- 3
Fast delivery
After payment you'll receive an email confirmation. The English PDF is sent to the same address, usually within minutes and at the latest within 1 business day.
- 4
Invoice included
A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.
Related Standards
GB/T 10003-2026 — Biaxially oriented polypropylene (BOPP) film
GB/T 10004-2026 — Plastic/Plastic laminated films and pouches for packaging
GB/T 10007-2026 — Rigid cellular plastics - Determination of shear properties
GB/T 23943-2009
$125.00