GB/T 23835.6-2009Lithium perchlorate anhydrous - Part 6: Determination of chlorate content (English PDF)
无水高氯酸锂 第6部分:氯酸盐含量的测定
This is a limited preview
Buy now to download the full PDF (15 pages)
Need quotation for your management?
Get a formal quotation for GB/T 23835.6-2009 in 30 minutes.
Issued by
SAMR; SAC
Level / Type
National · Recommended
Issue date
May 18, 2009
Implementation date
February 1, 2010
Scope
GB/T 23835.6-2009 is the English-translated version of 无水高氯酸锂 第6部分:氯酸盐含量的测定.
GB/T 23835.6-2009 is the sixth part of GB/T 23835, anhydrous lithium perchlorate, and it gives the method for determining the chlorate content of that product.
Clause 1 states that this part covers the summary of the method, the safety instructions, the general provisions, the reagents, the instruments and equipment, the analytical procedure and the calculation of results, that it applies to the determination of chlorate in anhydrous lithium perchlorate, and that the measuring range is 0.2 µg/mL to 4 µg/mL expressed as Cl.
Clause 3, Safety Tips, warns that the reagents used in the method are corrosive, that the operator must be careful, and that any splash on the skin must be washed off at once with water and treated immediately in severe cases.
Clause 4, General Provisions, states that unless other requirements are given the reagents are of analytical grade and the water is the third-grade water of GB/T 6682-2008, and that the impurity standard solutions and preparations used in the test are made up according to HG/T 3696.2 and HG/T 3696.3; those three documents are the ones clause 2 cites.
Clause 5, Method summary, states that the chlorate in the sample is reduced to chloride by ferrous sulfate in an acidic medium, that the total chlorine present as chloride ion is then measured by silver nitrate turbidimetry, and that the chlorate content is obtained by difference once the chloride already present in the sample is subtracted.
Clause 6 lists the reagents, among them a 1+2 nitric acid solution, a 17 g/L silver nitrate solution, a 1+4 glycerol solution, a 100 g/L ferrous sulfate solution that is to be freshly prepared before use, and a chloride standard solution of which 1 mL contains 0.010 mg of chlorine.
The foreword states that GB/T 23835 is divided into thirteen parts, that this part is published for the first time, and that the main drafting units are the Xinjiang Institute of Nonferrous Metals and the CNOOC Tianjin Chemical Research and Design Institute.
The draft on the page ends with clause 6, so the instruments, procedure and calculation clauses announced in clause 1 are not shown. It was issued on 18 May 2009 and has applied since 1 February 2010.
Found what you need?
Document preview — GB/T 23835.6-2009
National Standard of the People's Republic of China
- ICS
- 71.060.01
- Classification
- G 10
Issued by: State Administration for Market Regulation; Standardization Administration of the PRC
Contents
- Foreword
- 1 Scope
- 2 Normative references
- 3 Safety Tips
- 4 General Provisions
- 5 Method summary
- 6 Reagents
Foreword
GB/T 23835 "anhydrous lithium perchlorate" is divided into 13 parts.
--- Part 1. anhydrous lithium perchlorate technical requirements;
--- Part 2. Determination of the content of lithium perchlorate;
--- Part 3. Determination of moisture;
--- Part 4. Determination of water-insoluble matter content;
--- Part 5. Determination of chloride content;
--- Part 6. Determination of chlorate content;
--- Part 7. Determination of sulfate content;
--- Part 8. Determination of potassium and sodium content;
--- Part 9. Determination of calcium content;
--- Part 10. Determination of iron content;
--- Part 11. Determination of lead content;
--- Part 12. Determination of total nitrogen content;
--- Part 13. Determination of clarity.
This section first release.
1 Scope
This section provides a summary of the method of anhydrous lithium perchlorate, chlorate method for the determination of safety tips, general provisions, reagents, instruments, Equipment, analytical procedures and the results of calculations.
This section applies to the determination of anhydrous lithium perchlorate, chlorate content measurement range. 0.2µg/mL ~ 4µg/mL (Cl).
2 Normative references
The following documents contain provisions which, through reference GB/T 23835 in this section constitute provisions of this section. For dated references, All subsequent amendments (excluding corrections) or revisions do not apply to this section, however, encourage an agreement under this section Parties to study the latest versions of these documents. For undated reference documents, the latest versions apply to this section.
GB/T 6682-2008 analytical laboratory use specifications and test methods (ISO 3696. 1987, MOD)
HG/T 3696.2 Preparation of inorganic chemical products, chemical analysis of impurity standard solution
HG/T 3696.3 Preparations of inorganic chemical products, chemical analysis
3 Safety Tips
Reagents used in this test method is corrosive, the operator must be careful! As splashed on the skin should immediately wash with water, Yan In severe cases should be treated immediately.
4 General Provisions
This part of the reagents and water in the absence of other requirements specified, refers to three analytical reagent and GB/T 6682-2008 specified in water. Impurities used in the test standard solution, preparations and products, did not indicate when the other requirements, according to HG/T 3696.2, HG/T 3696.3 Provisions prepared.
5 Method summary
Sample of chlorate in an acidic medium, is reduced to ferrous sulfate, chloride, determination of total chlorine ion with silver nitrate turbidimetry, chlorine Subtracting the total amount of chloride ion in the presence of chlorine patterns, which is the difference in terms of the content of chlorate.
6 Reagents
6.1 the nitric acid solution. 1 + 2.
6.2 Silver nitrate solution. 17g/L.
6.3 Glycerol solution. 1 + 4.
6.4 Ferrous sulfate solution. 100g/L. Weigh 10g of ferrous sulfate (FeSO4 . 7H2O) was dissolved in an appropriate amount of water, plus 10mL of concentrated sulfuric acid, 1mL silver nitrate solution, diluted with water To 100mL, shake, filtration. The solution is using now.
6.5 Chloride Standard solution. 1mL solution containing chlorine (Cl) 0.010mg. Pipette 1mL chloride standard solution according to HG/T 3696.2 prepared, placed in 100mL volumetric flask, dilute with water to Mark and shake. The solution is using now.
......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 15 pages — is available in the English PDF.
Referenced standards
Normative references
- GB/T 6682-2008Water for analytical laboratory use - Specification and test methods
- HG/T 3696.3Inorganic chemical products - Preparation of standard solutions, reagent solutions and products for chemical analysis - Part 3: Preparation of reagent solutions and products
- HG/T 3696.2Inorganic chemical products - Preparation of standard solutions, reagent solutions and products for chemical analysis - Part 2: Preparation of impurity standard solutions
Similar standards
How to Download GB/T 23835.6-2009
- 1
Add to cart
Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.
- 2
Checkout
Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).
- 3
Fast delivery
After payment you'll receive an email confirmation. The English PDF is sent to the same address, usually within minutes and at the latest within 1 business day.
- 4
Invoice included
A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.
Related Standards
GB/T 6682-2008 — Water for analytical laboratory use - Specification and test methods
HG/T 3696.2-2002 — Inorganic chemical products Preparations of standard solutions for chemical analysis
HG/T 3696.2-2011 — Inorganic chemical products - Preparation of standard solutions, reagent solutions and products for chemical analysis - Part 2: Preparation of impurity standard solutions
GB/T 23835.6-2009
$105.00