Valid

GB/T 23773-2009Inorganic chemicals for industrial use - General method for determination of ammonium content - Nessler's reagent colorimetric method (English PDF)

无机化工产品中铵含量测定的通用方法 纳氏试剂比色法

Preview PDF

This is a limited preview

Buy now to download the full PDF (15 pages)

Need quotation for your management?

Get a formal quotation for GB/T 23773-2009 in 30 minutes.

Issued by

SAMR; SAC

Level / Type

National · Recommended

Issue date

May 13, 2009

Implementation date

January 1, 2010

Scope

GB/T 23773-2009 is the English-translated version of 无机化工产品中铵含量测定的通用方法 纳氏试剂比色法.

GB/T 23773-2009 is the Chinese standard "Inorganic chemicals for industrial use - General method for determination of ammonium content - Nessler's reagent colorimetric method".

Its scope clause reads: This standard specifies the general method of inorganic chemical products Determination of ammonium Nessler reagent colorimetric method feeds, safety tips, general Regulations, reagents, instruments, equipment, analytical procedures and the results of calculations.

This standard applies to the determination of trace inorganic chemical products, ammonium ions.

100mL of test solution volume, the concentration of ammonium ion rho (NH4) <=2mg/L. The test solution volume of 100mL, the visually minimum detectable concentration of 0.02mg/L. Using spectrophotometry Optical path length 1cm cuvette, the minimum detectable concentration of 0.05mg/L. When rho (NH4) = 1.0mg/L, the sensitivity is about 0.2 Absorbance units. Its clauses include method summary; safety tips; general provisions; reagents.

Found what you need?

Document preview — GB/T 23773-2009

National Standard of the People's Republic of China

ICS
71.060.01
Classification
G 10

Issued by: State Administration for Market Regulation; Standardization Administration of the PRC

Contents

  • 1 Scope
  • 2 Normative references
  • 3 Method summary
  • 4 Safety Tips
  • 5 General Provisions
  • 6 Reagents

1 Scope

This standard specifies the general method of inorganic chemical products Determination of ammonium Nessler reagent colorimetric method feeds, safety tips, general

Regulations, reagents, instruments, equipment, analytical procedures and the results of calculations.

This standard applies to the determination of trace inorganic chemical products, ammonium ions. 100mL of test solution volume, the concentration of ammonium ion

rho (NH4) <=2mg/L. The test solution volume of 100mL, the visually minimum detectable concentration of 0.02mg/L. Using spectrophotometry

Optical path length 1cm cuvette, the minimum detectable concentration of 0.05mg/L. When rho (NH4) = 1.0mg/L, the sensitivity is about 0.2

Absorbance units.

2 Normative references

The following documents contain provisions which, through reference in this standard and become the standard terms. For dated references, subsequent

Amendments (not including errata content) or revisions do not apply to this standard, however, encourage the parties to the agreement are based on research

Whether the latest versions of these documents. For undated reference documents, the latest versions apply to this standard.

GB/T 6682-2008 analytical laboratory use specifications and test methods (ISO 3696. 1987, MOD)

Preparation of HG/T 3696.2 inorganic chemical products, chemical analysis of impurity standard solution

Preparations of HG/T 3696.3 inorganic chemical products, chemical analysis

3 Method summary

In alkaline solution, the free ammonia or ammonium bound Nessler reagent to produce a light yellow to reddish brown insoluble compound. Ammonium content

Higher, and the resultant reddish-brown precipitation; ammonium content is low, the formation of a stable suspension, the available visual colorimetry standard than liquid ratio on

Or spectrophotometry.

4 Safety Tips

Reagents used in this test method are toxic or corrosive, the operator must be careful! Such as water splashed on the skin should immediately

Flushing, severe cases should be treated immediately.

5 General Provisions

This standard reagents and water, did not indicate when the other requirements, refer to analytically pure reagents and GB/T 6682-2008 specified three

Grade water.

Impurity standard solution, preparations and products needed to test, in the absence of other requirements specified according to HG/T 3696.2, HG/T 3696.3

Provisions prepared.

6 Reagents

6.1

No ammonia;

6.2 Sodium hydroxide solution

320g/L.

6.3 Ammonium standard solution I

1mL solution containing ammonium (NH4) 0.10mg;

Pipette Pipette 10mL ammonium standard solution according to HG/T 3696.2 prepared, placed in 100mL volumetric flask, dilute to the mark with water […]

......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 15 pages — is available in the English PDF.

Similar standards

How to Download GB/T 23773-2009

  1. 1

    Add to cart

    Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.

  2. 2

    Checkout

    Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).

  3. 3

    Fast delivery

    After payment you'll receive an email confirmation. The English PDF is sent to the same address, usually within minutes and at the latest within 1 business day.

  4. 4

    Invoice included

    A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.

Related Standards

English PDF
15 pages
Fast delivery
Invoice included
View Cart

Secure payment via Stripe

Payments accepted

VisaMastercardAmerican ExpressApple PayGoogle PayStripe

GB/T 23773-2009

$165.00