Valid

GB/T 23772-2009Inorganic chemicals for industrial use - General method for the determination of total nitrogen content - Nessler's reagent colorimetric method (English PDF)

无机化工产品中总氮含量测定的通用方法 蒸馏-纳氏试剂比色法

Preview PDF

This is a limited preview

Buy now to download the full PDF (15 pages)

Need quotation for your management?

Get a formal quotation for GB/T 23772-2009 in 30 minutes.

Issued by

SAMR; SAC

Level / Type

National · Recommended

Issue date

May 13, 2009

Implementation date

January 1, 2010

Scope

GB/T 23772-2009 is the English-translated version of 无机化工产品中总氮含量测定的通用方法 蒸馏-纳氏试剂比色法.

GB/T 23772-2009 is the Chinese standard "Inorganic chemicals for industrial use - General method for the determination of total nitrogen content - Nessler's reagent colorimetric method".

Its scope clause reads: This standard specifies the general method of producing inorganic chemicals Determination of total nitrogen Nessler's reagent colorimetric method feeds, safety tips, a General provisions, reagents, instruments, equipment, analytical procedures and the results of calculations.

This method is applicable to inorganic chemical products, trace inorganic nitrogen compounds (including nitrate, nitrite and ammonium) Determination of the total.

Check Measured in the range of 0.05µg/mL ~ 0.8µg/mL (in N gauge). Its clauses include method summary; safety tips; general provisions; reagents.

Found what you need?

Document preview — GB/T 23772-2009

National Standard of the People's Republic of China

ICS
71.060.01
Classification
G 10

Issued by: State Administration for Market Regulation; Standardization Administration of the PRC

Contents

  • 1 Scope
  • 2 Normative references
  • 3 Method summary
  • 4 Safety Tips
  • 5 General Provisions
  • 6 Reagents

1 Scope

This standard specifies the general method of producing inorganic chemicals Determination of total nitrogen Nessler's reagent colorimetric method feeds, safety tips, a

General provisions, reagents, instruments, equipment, analytical procedures and the results of calculations.

This method is applicable to inorganic chemical products, trace inorganic nitrogen compounds (including nitrate, nitrite and ammonium) Determination of the total. Check

Measured in the range of 0.05µg/mL ~ 0.8µg/mL (in N gauge).

2 Normative references

The following documents contain provisions which, through reference in this standard and become the standard terms. For dated references, subsequent

Amendments (not including errata content) or revisions do not apply to this standard, however, encourage the parties to the agreement are based on research

Whether the latest versions of these documents. For undated reference documents, the latest versions apply to this standard.

GB/T 6682-2008 analytical laboratory use specifications and test methods (ISO 3696. 1987, MOD)

Preparation of HG/T 3696.2 inorganic chemical products, chemical analysis of impurity standard solution

Preparations of HG/T 3696.3 inorganic chemical products, chemical analysis

3 Method summary

In alkaline solution, the alloy can be fixed nitrogen in the sample, nitrate, nitrite reduced to ammonia or ammonium. Ammonia or ammonium distilled from an alkaline solution

After that, the available Nessler colorimetric determination of total nitrogen content.

4 Safety Tips

Reagents used in this test method are toxic or corrosive, the operator must be careful! Such as water splashed on the skin should immediately

Flushing, severe cases should be treated immediately.

5 General Provisions

This standard reagents and water, did not indicate when the other requirements, refer to the three water analytical reagent and GB/T 6682-2008 requirements.

Impurity standard solution, formulations and product tests required in the absence of other requirements specified according to HG/T 3696.2, HG/T 3696.3

Provisions prepared.

6 Reagents

6.1

No ammonia.

6.2 Nitrogen alloy (Cu

50%, Al. 45%, Zn. 5%). particle diameter of not more than 0.85mm.

6.3 sulfuric acid solution

1 + 200.

6.4 Sodium hydroxide solution

320g/L.

6.5 N standard solution reservoir I

1mL solution containing nitrogen (N) 0.1mg.

Pipette Pipette 10mL nitrogen standard solution according to HG/T 3696.2 prepared, placed in 100mL volumetric flask, dilute to the mark with water

Degree, shake.

6.6 N standard solution II

1mL solution of nitrogen (N) 0.01mg.

Pipette Pipette 10mL nitrogen standard solution I, set 100mL flask, diluted with water to the mark. This solution should be

Formulated the day of use.

6.7

Nessler reagent.

......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 15 pages — is available in the English PDF.

Similar standards

How to Download GB/T 23772-2009

  1. 1

    Add to cart

    Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.

  2. 2

    Checkout

    Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).

  3. 3

    Fast delivery

    After payment you'll receive an email confirmation. The English PDF is sent to the same address, usually within minutes and at the latest within 1 business day.

  4. 4

    Invoice included

    A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.

Related Standards

English PDF
15 pages
Fast delivery
Invoice included
View Cart

Secure payment via Stripe

Payments accepted

VisaMastercardAmerican ExpressApple PayGoogle PayStripe

GB/T 23772-2009

$165.00