GB/T 23565.4-2009Sliding guide steel-plate die sets of stamping dies - Part 4: Four-pillar die sets (English PDF)

1 Scope

This section GB/T 23565 specifies the sliding guide plate mold die 4 post mold of dimensions and markings.

This section applies to the sliding guide die steel mold four pillar sets.

2 Normative references

The following documents contain provisions which, through reference GB/T 23565 in this section constitute provisions of this section. For dated references,

All subsequent amendments (excluding corrections) or revisions do not apply to this section, however, encourage an agreement under this section

Parties to study the latest versions of these documents. For undated reference documents, the latest versions apply to this section.

GB/T 2861.1 Part 1 die guide. slide guide pillar

GB/T 2861.3 Part 3 die guides. Slide guide bushings

GB/T 23562.4 lower die plate mold base - Part 4. Four pillar lower die

GB/T 23566.4 die mold base plate on the sliding guide - Part 4. Four die holder guide post

JB/T 8050 Die mold technical conditions

3 Dimensions

Sliding guide 4 post mold structure and dimensions shown in Figure 1, Table 1.

1 --- punch holder;

2 --- lower die;

3 --- pillar;

4 --- guide sleeve.

Note. Allow the use of removable guide post.

1 sliding guide 4 post mold […]