GB/T 23565.1-2009Sliding guide steel-plate die sets of stamping dies - Part 1: Rear-pillar die sets (English PDF)

1 Scope

This part of GB/T 23565 specifies the dimensions and marking of the rear guide post molds of the die slide guide steel mold frame.

This part is applicable to the rear guide post mold of the die slide guide steel plate mold.

2 normative reference documents

The terms of the following documents are the terms of this part by reference to this part of GB/T 23565. Any reference to the date of the document,

Any subsequent amendments (not including corrigenda) or revisions shall not apply to this part, however, it is encouraged to enter into an agreement under this Part

The parties study whether the latest versions of these files can be used. For undated references, the latest edition applies to this section.

GB/T 2861.1 Die guide devices - Part 1. Sliding guide posts

Die - oriented devices - Part 3. Sliding guide bushings GB/T GB/T 23562.1 Die steel plate under the mold part of the first part. the rear guide column under the mold base

GB/T 23566.1 Die for sliding guide plate on steel plate - Part 1. Die holder on rear side post

JB/T 8050 die mold frame technical conditions

3 size specifications

Sliding guide rear side of the column structure and size specifications shown in Figure 1, Table 1.

1 --- on the mold base; 3 --- guide column;

2 --- under the mold base; 4 --- guide sleeve.

Note. Allowable use of removable column.

Figure 1 sliding guide rear guide column mold […]