GB/T 23278.7-2009Methods for chemical analysis of sodium stannate - Part 7: Determination of alkali insoluble matter - Gravimetric analysis (English PDF)
锡酸钠化学分析方法 第7部分:碱不溶物的测定 重量法
This is a limited preview
Buy now to download the full PDF (18 pages)
Need quotation for your management?
Get a formal quotation for GB/T 23278.7-2009 in 30 minutes.
Issued by
SAMR; SAC
Level / Type
National · Recommended
Issue date
January 5, 2009
Implementation date
November 1, 2009
Scope
GB/T 23278.7-2009 is the English-translated version of 锡酸钠化学分析方法 第7部分:碱不溶物的测定 重量法.
GB/T 23278.7-2009 is the part of the Chinese series on the chemical analysis of sodium stannate that determines the tin held in the alkali-insoluble residue. It gives the summary of the method, the reagents and apparatus, the preparation of the test portion, the procedure, the calculation and the precision, with the test report.
It applies to contents between 0.050% and 0.500% of tin in the alkali-insoluble matter, which is the part of the tin that has not dissolved and is therefore lost to the process.
Producers of sodium stannate and the plating works that buy it use it. Issued on 5 January 2009, it has applied since 1 November 2009.
Found what you need?
Document preview — GB/T 23278.7-2009
National Standard of the People's Republic of China
- ICS
- 71.040.40
- Classification
- G 10
Issued by: State Administration for Market Regulation; Standardization Administration of the PRC
Contents
- Foreword
- 1 Scope
- 2 Method summary
- 3 Reagents
- 4 Sample
Foreword
GB/T 23278 "Methods for chemical analysis of sodium stannate" is divided into eight sections.
--- Part 1. Determination of tin content potassium iodate titration;
--- Part 2. Determination of iron content - 1,10-phenanthroline spectrophotometry;
--- Part 3. Determination of arsenic content of arsenic and antimony molybdenum blue spectrophotometric method;
--- Part 4. Determination of lead content - Atomic absorption spectrometry;
--- Part 5. Determination of antimony content - Malachite green spectrophotometry;
--- Part 6. Determination of the free base neutralization titration method;
--- Part 7. alkali insolubles - Gravimetric method;
--- Part 8. Determination of nitrate ion selective electrode method.
This is Part 7.
1 Scope
This section GB/T 23278 specifies the determination of tin in sodium alkali-insoluble content.
This section applies to the determination of tin in sodium alkali-insoluble content measured in the range of 0.050% to 0.500%.
2 Method summary
Sample with sodium hydroxide solution (10g/L) were dissolved, filtered and washed, the filters were placed in constant weight porcelain crucible, ashed. At 700 °C ~ Ignition to constant weight at 750 °C. Content determined by subtraction.
3 Reagents
Test water for the three distilled water.
3.1 Sodium hydroxide solution (10g/L). Weigh 10 g of sodium hydroxide rapidly in a beaker, a small amount of water to the surface may contain Na2CO3, with water after dissolution, diluted to 1L (reagent formulation should be used to remove carbon dioxide, water).
4 Sample
The sample should be sealed packaging.
Step 5 Analysis
5.1 Sample
Weigh 10g sample (m1), accurate to 0.001g.
5.2 Determination of the number of Independently two determinations, the mean value.
5.3 Blank test
Along with sample blank test (m1 0).
5.4 Determination
5.4.1 The sample (5.1) in 250mL beaker, sodium hydroxide solution was added 100mL (3.1), covered table dish, at 70 °C ~ 80 °C water bath for 30min, so the sample is dissolved.
5.4.2 Serve hot with a slow quantitative filter paper to 40mL sodium hydroxide solution (3.1) washing the beaker and filter paper 10 times, followed by hot water to Not alkaline (phenolphthalein test paper test).
5.4.3 The filter paper and the residue was transferred to a pre-ignition to constant weight (m1 2) porcelain crucible at about 350 °C ashing, and then heated up to 700 °C ~ 750 °C burning 20min, removed, coolish, into the dryer, cooling 30min, weigh (m1).
Calculation results of the analysis of 6 Alkali insoluble material content quality base insolubles fraction w1 alkali insoluble matter and its value is expressed in%, according to formula (1).
W1 alkali insoluble matter = 1- 2- m1 m1 m1 0 M1 x 100 (1)
......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 18 pages — is available in the English PDF.
Similar standards
How to Download GB/T 23278.7-2009
- 1
Add to cart
Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.
- 2
Checkout
Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).
- 3
Fast delivery
After payment you'll receive an email confirmation. The English PDF is sent to the same address, usually within minutes and at the latest within 1 business day.
- 4
Invoice included
A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.
Related Standards
GB/T 23278.8-2009 — Methods for chemical analysis of sodium stannate - Part 8: Determination of nitrate content - Ion selective electrode method
GB/T 23278.6-2009 — Methods for chemical analysis of sodium stannate - Part 6: Determination of free alkali content - Titration
GB/T 23278.5-2009 — Methods for chemical analysis of sodium stannate - Part 5: Determination of antimony content - Malachite green photometric method
GB/T 23278.7-2009
$75.00