GB/T 21058-2007Inorganic chemical for industrial use - General method for mercury content-Flameless atomic absorption spectrometric method (English PDF)
无机化工产品中汞含量测定的通用方法 无火焰原子吸收光谱法
This is a limited preview
Buy now to download the full PDF (15 pages)
Need quotation for your management?
Get a formal quotation for GB/T 21058-2007 in 30 minutes.
Issued by
SAMR; SAC
Level / Type
National · Recommended
Issue date
August 13, 2007
Implementation date
February 1, 2008
Scope
GB/T 21058-2007 is the English-translated version of 无机化工产品中汞含量测定的通用方法 无火焰原子吸收光谱法.
GB/T 21058-2007 is the Chinese standard "Inorganic chemical for industrial use - General method for mercury content-Flameless atomic absorption spectrometric method".
Its scope clause reads: This standard specifies the determination of inorganic chemical products, mercury content in the general method --- flameless atomic absorption spectrometry.
This standard applies to the determination of inorganic chemical products, mercury content. In the preparation of the test solution, the reference should be related to the analysis of the standard product standards make the necessary changes to fit the measured product set.
This standard applies to mercury ion concentration of the test solution was taken 0.04µg/mL ~ 40µg/mL. Its clauses include test method.
Found what you need?
Document preview — GB/T 21058-2007
National Standard of the People's Republic of China
- ICS
- 71.060.01
- Classification
- G 10
Issued by: State Administration for Market Regulation; Standardization Administration of the PRC
Contents
- 1 Scope
- 2 Normative references
- 3 Test Method
- 3.1 Safety Tips
- 3.2 General Provisions
- 3.3 Principles
- 3.4 Reagents and solutions
1 Scope
This standard specifies the determination of inorganic chemical products, mercury content in the general method --- flameless atomic absorption spectrometry.
This standard applies to the determination of inorganic chemical products, mercury content.
In the preparation of the test solution, the reference should be related to the analysis of the standard product standards make the necessary changes to fit the measured product set. This standard applies to mercury ion concentration of the test solution was taken 0.04µg/mL ~ 40µg/mL.
2 Normative references
The following documents contain provisions which, through reference in this standard and become the standard terms. For dated references, subsequent
Amendments (not including errata content) or revisions do not apply to this standard, however, encourage the parties to the agreement are based on research
Whether the latest versions of these documents. For undated reference documents, the latest versions apply to this standard.
Laboratory use specifications and test methods (. 1987 neq ISO 3696) GB/T 6682-1992 Analysis
Preparations of HG/T 3696.3 inorganic chemical products, chemical analysis
3 Test Method
3.1 Safety Tips
Reagents used in this test method are toxic or corrosive, the operator must be careful! Such as water splashed on the skin should immediately
Flushing, severe cases should be treated immediately.
3.2 General Provisions
This standard reagents and water, did not indicate when the other requirements, refer to analytically pure reagents and GB/T 6682-1992 regulations II Grade water.
Tests required preparations and products, the provisions of HG/T 3696.3 it did not indicate when prepared according to other requirements.
3.3 Principles
Samples were dissolved mercury compounds contained in the acidic solution into the ion state exists, a reducing agent is added to the atomicity (elemental mercury vapor).
By air out of mercury into the inner quartz tube measuring mercury 253.7nm wavelength at which the absorbance in a range of concentrations and mercury content positively
Than on the working curve Richard mercury content.
3.4 Reagents and solutions
3.4.1 Nitric acid
pure class distinctions.
3.4.2 Potassium dichromate
pure class distinctions.
3.4.3
nitrate - potassium dichromate solution.
Weigh 5.0g potassium dichromate (3.4.2) dissolved in water was added 5mL nitric acid (3.4.1), diluted with water to 100mL.
3.4.4 stannous chloride solution
100g/L.
3.4.5 Mercury standard stock solution I
1mL solution containing mercury (Hg) 1.0mg.
Weigh 0.1354g pre-sulfated drier 24h mercuric chloride, placed in 100mL beaker, nitrate - potassium dichromate solution
Solution (3.4.3) was dissolved, all transferred to 100mL volumetric flask, with nitric acid - potassium dichromate solution is diluted to the mark. Placed in the refrigerator internal security
Deposit, valid for one year.
3.4.6 Mercury standard stock solution II
1mL solution containing mercury (Hg) 10µg.
......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 15 pages — is available in the English PDF.
Referenced standards
Similar standards
How to Download GB/T 21058-2007
- 1
Add to cart
Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.
- 2
Checkout
Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).
- 3
Fast delivery
After payment you'll receive an email confirmation. The English PDF is sent to the same address, usually within minutes and at the latest within 1 business day.
- 4
Invoice included
A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.
Related Standards
GB/T 10003-2026 — Biaxially oriented polypropylene (BOPP) film
GB/T 10004-2026 — Plastic/Plastic laminated films and pouches for packaging
GB/T 10007-2026 — Rigid cellular plastics - Determination of shear properties
GB/T 21058-2007
$135.00