GB/T 19314.4-2019Small craft -- Hull construction and scantlings -- Part 4: Workshop and manufacturing (English PDF)

Foreword

GB/T 19314 "Small boat hull structure and component size" is divided into 9 parts.

--- Part 1. Materials. thermosetting resins, glass fiber reinforced plastics, reference laminates;

--- Part 2. Materials. core materials for embedded structures, embedded materials;

--- Part 3. Materials. steel, aluminum alloy, wood, other materials;

--- Part 4. Workshop and manufacturing;

--- Part 5. Determination of design pressure, design stress and component size of single vessel;

--- Part 6. Structural arrangements and details;

--- Part 7. Determination of the dimensions of multi-hull ship components;

--- Part 8. Rudder;

--- Part 9. Sailboat possession.

This part is the fourth part of GB/T 19314.

This part is drafted in accordance with the rules given in GB/T 1.1-2009.

This part uses the translation method equivalent to ISO 12215-4.2002 "Small boat hull structure and component dimensions Part 4. Workshop and system

Made.

The documents of our country that have a consistent correspondence with the international documents referenced in this part are as follows.

---GB/T 19916-2005 Main data of small boats (ISO 8666.2002, IDT)

This part is proposed and managed by the National Small Boat Standardization Technical Committee (SAC/TC241).

This section drafted by. China Shipbuilding Corporation, the 7th Eighteenth Institute.

1 Scope

This part of GB/T 19314 specifies the conditions of the shop, the storage and processing of the materials, and the manufacturing requirements for the boat. This section applies to

A dinghy with a hull length (LH) of not more than 24 m in accordance with ISO 8666.

This section does not address health and safety requirements.

Note. The root cause of the preparation of this part of GB/T 19314 is that the workshop conditions have a significant impact on the short-term and long-term mechanical properties of the yacht, and according to GB/T 19314.5

The determined component dimensions are based on the appropriate materials and manufacturing conditions used.

2 Normative references

The following documents are indispensable for the application of this document. For dated references, only dated versions apply to this document. For undated references, the latest edition (including all amendments) applies to this document.

GB/T 19314.1-2003 hull structure and component dimensions - Part 1. Materials. thermosetting resin, glass reinforced

Plastic, reference laminate (ISO 12215-1.2000, IDT)

GB/T 19314.3-2019 hull structure and component dimensions - Part 3. Materials. steel, aluminium alloy, timber, other materials

(ISO 12215-3.2002, IDT)

GB/T 19314.5-2019 hull structure and component dimensions - Part 5. singular design pressure, design stress,

Determination of dimensions (ISO 12215-5.2008, IDT)

ISO 8666.20021) Small boat main data (Smalcraft-Principaldata)

1) This document was not published at the time of ISO 12215-4.2002, and was published in.2002.

3 Production of fiber reinforced plastic (FRP) boats