GB/T 13917.5-2026Laboratory efficacy test methods and criteria for public health insecticides for pesticide registration - Part 5: Vaporizing mats (English PDF)

Foreword

This document complies with the provisions of GB/T 1.1-2020 "Standardization Work Guidelines Part

1.Structure and Drafting Rules of Standardization Documents". Drafting. This document is Part 5 of GB/T 13917 "Indoor Efficacy Tests and Evaluation of Sanitary Insecticides for Pesticide Registration". GB/T 13917 The following sections have been released.

1.Spraying formulations;

4.Mosquito Coils;

5.Electric Mosquito Repellent Mats;

6.Electric Mosquito Repellent Liquid;

8.Powders and Pencils;

10.Simulated Scene This document replaces GB/T 13917.5-2009 "Indoor Efficacy Testing and Evaluation of Sanitary Insecticides for Pesticide Registration - Part

5.Electrothermal Treatment". Compared with GB/T 13917.5-2009, the main technical changes in "Mosquito Repellent Tablets" are as follows, apart from structural adjustments and editorial modifications.

a) Added terms and definitions for "electric mosquito repellent mats," "sensitive strains," and "knockout time" (see Chapter 3);

b) The requirements for the test reagents have been increased (see 4.1);

c) The requirements for the test targets have been changed (see 4.2, Chapter 2 of the.2009 edition);

d) Requirements for mosquito suction tubes or mosquito suction devices, stopwatches, and counters have been added (see 5.4, 5.5, and 5.6);

e) The test conditions were changed (see 6.1,

4 Test materials

4.1 Test reagents Please specify the generic name or code of the drug in Chinese/English, dosage form, content of active ingredient, manufacturer, production date or batch number, etc.

4.2 Test Target Culexpipienspallens (northern region) or Culexpipiens quinquefasciatus (southern region) (Region), sensitive strains of test insects were reared according to the method in NY/T 1964.2, and selected from the 3rd to 5th day after emergence, with a body weight of (2.0±0.2) mg. Unfed female adult worms.

5 Instruments and Equipment

5.1 Cylindrical Device The cylindrical device is shown in Figure 1.A colorless and transparent cylinder (C) is mounted on a support (I), and there is a colorless and transparent circular plate (E, F) on the top and bottom of the cylinder. The upper circular plate (E) has a hole in the center, which is plugged with a rubber stopper (G); the lower circular plate (F) has a hole in the center, which is covered with a 12-mesh (1 mesh = 2.5cm) iron sieve. (J), During the test, the electric mosquito repellent coil (A) heater (B) was placed below the round hole, and the round hole was plugged with a rubber stopper (H) before and after the test; the cylinder and the upper and lower... The joints of the circular plates are sealed with sealing grooves or rubber gaskets (D1, D2).

5.2 Box Assembly The box assembly is shown in Figure 2.A glass box (B) is mounted on a support (E). A small door (C) is located at the lower corner of one side of the box. There is also an insect release hole (F) at the top, which can be sealed with a rubber stopper, and another side is a large door (D). The device should be sealed during testing.

5.3 Electric Mosquito Repellent Mat Heater Voltage 220V.

5.4 Mosquito suction tube or mosquito suction device Mosquito suction tube. inner diameter 5cm, length 15cm~20cm, one end is an embedded 1cm diameter flared mouth, and the other end is a wide mouth connecting the suction tube. Mosquito suction device. handheld, airflow 3m^3/min~5m^3/min. 5.5-stopwatch Accuracy ±0.5s.

5.6 Counter Error 1000±1.

6 Test Methods

6.1 Test Conditions Temperature. (26±2)°C. Relative humidity. (60±10)%.

6.2 Judgment Criteria Knockdown. All six legs roll upwards or sideways and cannot crawl.

9 Results and Report Writing

Based on the statistical results, an analysis and evaluation were conducted, and an experimental report was written, including. detailed information on the test reagents, the selection of target materials, and the environment. Condition control, experimental treatment, replication and investigation methods, statistical analysis of results, etc., and list the raw data.