GB/T 10479-2009Aluminum rail tank cars (English PDF)

Foreword

This standard replaces GB 10479-1989 "aluminum railway tanker technical conditions." This standard compared with GB 10479-1989 main changes are as follows.

--- Adds a chapter of terms and definitions;

--- Design adds a chapter;

--- According to the State Council department in charge of tank reload speed requirements of each chapter has been revised standards;

--- Manufacturing part made more stringent requirements, a clear assessment followed standard welding;

--- Increasing the type test on the vehicle after the completion Tank test methods and inspection rules, routine test and line test run Requirements nuclear tests;

--- Canceled Appendix B "grade aluminum weld X-ray detection Classification (Supplement)" without compromising the standard JB/T 4730 "Pressure Equipment Detection" instead.

Appendix A of this standard is an informative annex.

The standard proposed by China Petroleum and Chemical Industry Association.

1 Scope

This standard specifies the design temperature saturated steam at medium pressure is less than 0.1MPa aluminum (ie, body part housing, head to Its members are welded aluminum and aluminum alloy) railroad tank car design, manufacture, inspection and acceptance requirements.

This standard applies to 1435mm standard gauge transport of concentrated nitric acid, acetic acid, ethylene, hydrogen peroxide, acrylate and similar media With aluminum railroad tank (hereinafter referred to as tanker).

That can not be used to determine the structure of the standard size of tankers, including allowing the use of finite element stress analysis design.

2 Normative references

The following documents contain provisions which, through reference in this standard and become the standard terms. For dated references, subsequent Amendments (not including errata content) or revisions do not apply to this standard, however, encourage the parties to the agreement are based on research Whether the latest versions of these documents. For undated reference documents, the latest versions apply to this standard.

GB 146.1 standard gauge railway rolling stock clearance

GB 150 steel pressure vessels

GB/T 232 metallic materials - Bend test (GB/T 232-1999, eqvISO 7438. 1985)

GB/T 700 carbon structural steel (GB/T 700-2006, ISO 630:1995, NEQ)

GB/T 1348 Ductile Iron

GB/T 1591 high strength low alloy structural steel

GB/T 1804 General tolerances Tolerances for linear and angular dimensions without individual tolerance (GB/T 1804-2000, eqvISO 2768-1. 1989)

GB/T 3195 aluminum and aluminum wire drawing round

GB/T 3880 (all parts) general industrial aluminum and aluminum alloy sheet, strip

GB/T 4437.1 aluminum and aluminum alloy extruded tubes - Part 1: Seamless tubes

GB/T 4549 (all parts), Railway vehicle vocabulary

GB/T 5599 railway vehicle dynamics and performance evaluation test evaluation norms

GB/T 5601 railway wagons for inspecting and testing rules

GB/T 6893 aluminum and aluminum alloy drawn (rolled) Seamless

GB/T 7659 carbon steel welded structure Castings (GB/T 7659-1987, neqASTMA216. 1982)

GB/T 8492 General purpose heat-resistant steel and alloy castings (GB/T 8492-2002, eqvISO 11973.1999)

GB/T 9439 Gray Iron Castings

GB/T 10858 aluminum and aluminum wire (GB/T 10858-2008, ISO 18273:2004, MOD)

JB/T 4730 (all parts), non-destructive testing of pressure equipment

JB/T 4734-2002 welded aluminum container

JB/T 4746-2002 Steel Pressure Vessel Head

JJG140 Railway Tank Car Volume verification procedures

TB/T 1.1 General rules railway vehicle mark

TB/T 1.2 railway vehicle mark text and fonts

TB/T 493 railway vehicle coupler and draft gear assembly technical conditions

TB/T 1134 truck timber technical conditions