SN/T 1936.3-2007Inspection rules of large packagings for rxport dangerous goods. Part 3: Use appraisal (English PDF)

Foreword

SN/T 1936 "export of dangerous goods Bulk test method" is divided into three parts.

--- Part 1. General;

--- Part 2. Performance test;

--- Part 3. Use appraisal.

This section SN/T 1936 Part 3.

The partial modification of the use of the United Nations "on the Recommendations on the Transport of Dangerous Goods Model Regulations ·" (14th revised edition), its technical content Fully consistent with the above regulations, according to the text format GB/T 1.1-2000 made editorial changes.

This section proposed and managed by the National Certification and Accreditation Administration Committee.

This section is drafted. Tianjin People's Republic of China Exit Inspection and Quarantine.

1 Scope

SN/T 1936 provisions of this part of the test using the Bulk identification requirements for export of dangerous goods, sampling, identification and authentication rules.

This section applies to the export of dangerous goods identification using large packaging.

2 Normative references

The following documents contain provisions which, through reference SN/T 1936 this section, constitute provisions of this part. For dated reference documents Member, all subsequent amendments (not including errata content) or revisions do not apply to this section, however, encouraged to reach under this section Parties to research agreement to use the latest versions of these documents. For undated reference documents, the latest versions apply to this section.

GB/T 2828.1 Sampling procedures for inspection - Part 1. by acceptance quality limit (AQL) retrieval batch inspection sampling plan GB 12268 of dangerous goods SN/T 1936.1 dangerous goods for export Bulk test methods - Part 1. General SN/T 1936.2 dangerous goods for export Bulk test methods Part 2. Performance test

3 Terms and Definitions

SN/T 1936.1 and established the following terms and definitions apply to SN/T 1936 of this part.

In the same materials, the same structure and the same process for the production of large package a batch identification.

4 Requirements

4.1 Bulk cast printed, print paste marks, color marks and labels of dangerous goods should be clear and precise, in line with SN/T 1936.1 has Off requirements.

4.2 Bulk appearance should be clean, does not allow residues, contamination or leakage.

4.3 Where the use of seals Bulk transport of dangerous goods should be in the on-site inspection conducted seals.

4.4 using the unit should be selected Bulk nature of the contents of dangerous goods adapt its performance shall comply with SN/T 1936.2 of.

4.5 Bulk packaging level equal to or higher than the requirements of the packaging containing the goods level.

4.6 provided by the State Quality Supervision, Inspection and Quarantine departments authorized inspection agency issued the dangerous goods classification, grading and risk in the following cases should be Risk characteristics inspection reports.

--- First transportation or production;

--- First outlet;

--- National quality inspection departments as deemed necessary.

4.7 Bulk bottom discharge valve have, should have closed the fastening characteristics, discharge devices are always in good condition, and to prevent any accidental opening.

Plastic 4.8 was first used, in-band (plated) Bulk layer should provide six months or more chemical compatibility test qualified report.

4.9 Closed Cup for shipping to or lower than 60 °C of liquid 60 °C, prone or shipping powders for dust explosion should take Anti-static measures.