GB/T 94.3-2008Specification for spring washers - Curved and wave spring washers (English PDF)

Foreword

This section is one of the "spring washers" series of standards GB/T 94. The series includes.

--- GB/T 94.1-2008 spring washers spring washers;

--- GB/T 94.2-1987 toothed spring washers, serrated lock washer;

--- GB/T 94.3-2008 saddle-shaped spring washers, wave spring washers. This section is GB/T Part 3 94.

This Part replaces GB/T 94.3-1987 "saddle-shaped spring washers, wave spring washers." Section compared with the GB/T 94.3-1987 The main changes are as follows.

--- Modify reference standard (Chapter 2);

--- Increase spring steel washers Vickers hardness and the hardness of the copper alloy washers (see table 1);

--- Increasing spring steel washer "sheet non-electrolytic zinc coating" surface treatment (Table 1).

1 Scope

This section provides the saddle and wave spring washers technical conditions.

2 Normative references

The following documents contain provisions which, through reference in this text, constitute provisions of this part. For dated references, subsequent Amendments (not including errata content) or revisions do not apply to this section, however, encourage the parties to this part of the research agreement Whether the latest versions of these documents. For undated reference documents, the latest versions apply to this section.

GB/T 90.1 fasteners acceptance inspection (GB/T 90.1-2002, ISO 3269:2000, IDT)

GB/T 90.2 Fasteners marking and packaging

GB/T 1222 spring steel

GB/T 3114 copper and copper alloy flat wire

GB/T 230.1 Metallic Rockwell hardness test - Part 1: Test methods

GB/T 4340.1 Vickers hardness test - Part 1: Test methods

GB/T 5267.1 fasteners plating layer (GB/T 5267.1-2002, ISO 4042:1999, IDT)

GB/T 5267.2 fasteners non-electrolytic zinc flake coating (GB/T 5267.2-2002, ISO 10683:2000, IDT)

3 Technical requirements