GB/T 7260.40-2020Uninterruptible power systems (UPS) - Part 4: Environmental aspects. Requirements and reporting (English PDF)

1 Scope

This part of GB/T 7260 specifies the procedures and requirements for environmental declarations of uninterruptible power supply systems:

Any negative effects of the power system on the environment throughout its life cycle: This part is coordinated with applicable similar general environmental standards, and includes

Contains additional detailed information related to the uninterruptible power supply system:

This part is applicable to fixed frequency, single-phase or three-phase AC output voltage not exceeding 1000V, movable, not easy to move and fixed installation

The uninterruptible power supply system is regulated by IEC 62040-1, IEC 62040-2 and IEC 62040-3:2011:

Can device:

This section does not include:

---Traditional AC input and output switchboard;

---DC switchboard and related switches (e:g: battery switch, rectifier output switch or inverter input switch);

--- Independent static switching system specified by IEC 62310-1, IEC 62310-2 and IEC 62310-3;

---The output voltage comes from the system of rotating electric machine:

2 Normative references

The following documents are indispensable for the application of this document: For dated reference documents, only the dated version applies to this article

Pieces: For undated references, the latest version (including all amendments) applies to this document:

IEC 62040-3:2011 Uninterruptible power supply system (UPS) Part 3: Method for determining performance and test requirements [Uninter- ruptiblepowersystems(UPS)-Part 3:Methodofspecifyingtheperformanceandtestrequirements]

IEC 62474:2012 Electrical industry and material declaration for electrical products (Materialdeclarationforproductsofand fortheelectrotechnicalindustry)

3 Terms and definitions

The following terms and definitions apply to this document:

3:1

Endoflife

The life cycle phase of a product from the phase of its intended use:

3:2

Endoflifetreatment

Any operation after waste is placed in a recycling facility or ready for disposal:

Note: Operations include dismantling, material separation and processing:

3:3

Usephase

The life cycle stage of a product from the beginning of its use to the end of its service life: […]