GB/T 44215-2024Glassware—Test method for inner surface hot end spraying liquid (English PDF)

Foreword

This document is in accordance with the provisions of GB/T 1.1-2020 "Guidelines for standardization work Part 1: Structure and drafting rules for standardization documents" Drafting is required.

Please note that some of the contents of this document may involve patents. The issuing organization of this document does not assume the responsibility for identifying patents.

This document was proposed by China Light Industry Federation.

This document is under the jurisdiction of the National Technical Committee for Standardization of Glass Instruments (SAC/TC 178).

This document was drafted by: Shandong Pharmaceutical Glass Co., Ltd. and Beijing Pharmaceutical Packaging Materials Inspection Institute.

The main drafters of this document are Yuan Hengxin, Yuan Chunmei, Xie Haixian and Chen Fuqiang.

Hot end spraying liquid on the inner surface of glass instruments Sedimentation test method

1 Scope

This document specifies the principles, reagents and materials, instruments and equipment, samples, test methods and procedures for the test of the deposition of the hot end spray liquid on the inner surface of glassware.

Steps, data processing, result presentation, test report, etc.

This document applies to the test method for the amount of tin deposited on the inner surface of glassware after hot end spraying.

2 Normative references

GB/T 622

GB/T 629

GB/T 6582-2021

GB/T 6682

GB/T 12806-2011

GB/T 15724

3 Terms and definitions

The following terms and definitions apply to this document.

4 Principle

Add a nominal volume of sodium hydroxide solution into the glassware and use an ultrasonic oscillator to perform ultrasonic extraction to dissolve the tin deposited on the inner surface.

The solution was dissolved in sodium hydroxide solution, and hydrochloric acid solution was added to adjust the pH and make the volume constant. The solution was analyzed by inductively coupled plasma emission spectrometer and other instruments.

The amount of tin element in the liquid is tested to obtain the deposition amount of the hot end spraying liquid on the inner surface.